ZEBRA CS6080 Barcode Scanner Instructions
- June 21, 2024
- ZEBRA
Table of Contents
CS6080
United States and Canada Regulatory
Radio Frequency Interference Notices
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmfulb
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radio Frequency Interference Requirements – Canada
Innovation, Science and Economic Development Canada ICES-003 Compliance Label:
CAN ICES-3 ([B])/NMB-3([B])
This device complies with Innovation, Science and Economic Development
Canada’s licence-exempt RSSs. Operation is subject to the following two
conditions: (1) This device may not cause interference; and (2) This device
must accept any interference, including interference that may cause undesired
operation of the device.
RF Exposure Requirements – FCC and ISED
The FCC has granted an Equipment Authorization for this device with all
reported SAR levels evaluated in compliance with the FCC RF emission
guidelines. SAR information on this device is on file with the FCC and can be
found under the Display Grant section of
fcc.gov/oet/ea/fccid.
Mobile Devices
This equipment complies with RF Exposure limits established for an
uncontrolled environment (General Population). This equipment should be
installed and operated in such a way that a separation distance of greater
than 20 centimeters is maintained between the transmitter’s radiating
structure(s) and the body of the user or nearby persons.
Co-located Statement
To comply with FCC RF exposure compliance requirement, the antenna used for
this transmitter must not be co-located (within 20 cm) or operating in
conjunction with any other transmitter/antenna except those already approved
in this filling.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>