Rebel RB-2001-CH AC Charger User Manual

: June 21, 2024
: Rebel

Table of Contents

Rebel RB-2001-CH AC Charger
Product Specifications
Product Usage Instructions
Frequently Asked Questions
Charger use and care
Charging
Charging indicators
Documents / Resources

Rebel RB-2001-CH AC Charger

Rebel-RB-2001-CH-AC-Charger-PRODUCT

Product Specifications

Model: RB-2001-CH, RB-2003-CH
Manufacturer: Lechpol Electronics Leszek Sp.k.
Country of Origin: Made in China
Website:www.rebelelectro.com

Product Usage Instructions

Charger Use and Care

Do not attempt to open or disassemble the charger. If damaged, return for repair.
Avoid exposing the charger to heat sources to prevent damage.
Avoid water, moisture, and cold to prevent electric shock.
Stop using the charger if the power cord or plug is damaged.

Charging Process

Slide the battery into the power tool until it locks in place.
The AC charger has LED indicators:

Red: Battery charging in progress
Green: Battery fully charged

Correct Disposal

Follow local laws for proper disposal of the products as waste electrical & electronic equipment.

Frequently Asked Questions

Q: Can I charge non-rechargeable batteries with this charger?

A: No, do not attempt to charge non-rechargeable batteries as it poses a risk of explosion.

Q: What should I do if the charger is damaged?

A: Stop using the charger and return it for repair to an authorized service center or a qualified person.

Q: How can I tell when the battery is fully charged?

A: The charging indicators on the AC charger will show a green light when the battery is fully charged.

Charger use and care

Do not attempt to open or disassemble the charger. If the charger has been dropped or is damaged in any way, stop using it and do not attempt to repair it.
- Return the charger for repair to an authorized service center or a qualified person, to avoid any danger to the user; or discard it according to local laws.
Protect the charger against any heat source (e.g. direct sunlight exposure, fire, heater) to prevent any damage to the charger.
Do not expose the charger to water, moisture, and cold. Risk of electric shock.
If the power cord or the plug becomes damaged, stop using the charger until it has been repaired by a qualified person.
- If the supply cord is damaged, it must be replaced by the manufacturer or its authorized service center, to avoid a hazard. Risk of electric shock.
Only use the charger provided with the tool, or the same type or same model charger to charge the battery. The use of other types of chargers increases the risk of electric shock, personal injury, and damage.
Never attempt to recharge non-rechargeable batteries. Explosion hazard.
Only use the charger at ambient temperatures between +10°C and +40°C. Store the charger in a dry location protected from cold where the temperature would not exceed +40°C.
The charger is intended for indoor use only. Place the charger on a solid, flat non-flammable surface and away from any flammable materials when re-charging the battery pack.
Do not recharge the battery pack in a wet or humid environment. The charger and battery pack may heat during the charging process.

Charging

Place the AC charger on a flat and stable surface within about 1 meter from the power supply socket.
Remove the battery from the power tool. Press and hold the battery release button and at the same time slide out the battery.
Slide the battery to the AC charger maximally so that it locks in place (RB-2001-CH) /insert the plug of the mains charger into the charging port on the battery (RB-2003-CH).
Connect the AC charger to the power supply socket.
When the battery is fully charged, slide it out from the AC charger and slide it into the power tool so that it locks in place.

Charging indicators

The AC charger has charging indicators that indicate the status of the charging process.

LED	Status
Red	Battery charging in progress
Green	Battery charging finished, the battery is fully charged

AC charger and battery may heat up during charging. It is a normal behavior.
When the power tool is not in use, it is recommended to charge the battery every three months.
When you notice that the power tool performance is decreasing, recharge the battery.

LEARN MORE

For more information on this device visit: www.rebelelectro.com.
Read the owner’s manual carefully before using your device.
Visit www.rebelelectro.com website for more products and accessories.

Correct Disposal of This Product

Waste Electrical & Electronic Equipment
Applicable in the European Union and other European countries with separate collection systems
This marking shown on the product or its literature indicates that it should not be disposed of with other household wastes at the end of its working life.
To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of waste and recycle it responsibly to promote the sustainable reuse of material resources.
Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and conditions of the purchase contract.
This product should not be mixed with other commercial wastes for disposal.
Made in China for Lechpol Electronics Leszek Sp.k., ul. Garwolińska 1, 08-400 Miętne.
www.rebelelectro.com