PHILIPS HC3505 Hair Clipper User Manual

HC3505
User Manual

HC3505 Hair Clipper

Introduction

Congratulations on your purchase and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.

General description (Fig. 1)

General description (Fig. 1)

1 Trimming comb 1-23mm
2 Cutting unit
3 Length setting adjustment slider
4 On/off button| 5 Charging light
6 Small plug
7 Supply unit
8 Brush
---|---

Important safety information

Read this important information carefully before you use the appliance and its accessories and save it for future reference. The accessories supplied may vary for different products.
Danger

• Keep the appliance and the mains cord dry (Fig. 2).

Warning

• This symbol means that the appliance is double-insulated (Fig. 3).
• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
• If the mains cord is damaged, you must have it replaced by Philips, a service center authorized by Philips or similarly qualified persons in order to avoid a hazard.
• Always check the appliance before you use it. Do not use the appliance if it is damaged, as this may cause injury. Always replace a damaged part with one of the original type.

Caution

• Only use this appliance for its intended purpose as shown in the user manual.
• For hygienic reasons, the appliance should only be used by one person.
• Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance.

Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and regulations regarding exposure to electromagnetic fields.

General

• The supply unit is suitable for mains voltages ranging from 100 to 240 volts.

Using the appliance

The hair length settings are indicated in millimeters, the comb cuts the hair to a length of 1mm to 23mm. The settings correspond to the remaining hair length after trimming.

Warning: Be careful when you trim for the first time. Do not move the trimmer too fast. Make smooth and gentle movements.

Tip: Start trimming at a high length setting and reduce the length setting gradually until you have reached the desired hair length.

Switching the appliance on and off
Note: You can only use the appliance when it is connected to the wall socket.

1. Insert the small plug into the appliance and put the supply unit in the wall socket (Fig. 4).
2. Switch on the appliance by sliding the power switch upwards (Fig. 5).
3. Switch the appliance off by sliding the power switch downwards (Fig. 6).

Trimming with the trimming comb

1. Attach the trimming comb to the appliance (Fig. 7).

2. slide the length setting adjustment slider to the desired length setting (Fig. 8).
   Note: When you trim for the first time, start at the highest length setting to familiarise yourself with the appliance.

3. Switch on the appliance (Fig. 5).

4. Move the appliance slowly and with light pressure against the direction of hair growth (Fig. 9).

Note: Make sure that the flat part of the comb always stays in contact with the skin to obtain an even result (Fig. 10).

Trimming without comb
Use the trimmer without the trimming comb to trim hair close to the skin (0.5 mm) or to contour the neckline and sideburns.

Caution: Be careful when you trim without comb because the cutting unit removes every hair it touches.

1. Pull the comb off the appliance (Fig. 11).
2. Switch on the appliance (Fig. 5).
3. Touch the hair lightly with the trimmer. Make well-controlled movements (Fig. 12).

Cleaning

Warning: Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance.
Warning: Never immerse the appliance in water, or rinse it under the tap.

Note: Only the cutting element and the comb can be cleaned with water.

1. Make sure that the appliance is switched off and disconnected from the mains.
2. Wipe the housing of the appliance with a dry cloth.
3. Remove the comb. Clean it with the cleaning brush and rinse with water (Fig. 13).
4. Press the release button. The cutting unit comes off the appliance (Fig. 14).
5. Clean the cutting unit with the cleaning brush or rinse it under the tap (Fig. 15).
6. Clean the inside of the appliance with the cleaning brush (Fig. 16).
7. Shake off excess water. To reattach the cutting unit, insert the lug of the cutting unit into the guiding slot.
8. Insert the lug of the cutting unit into the guiding slot and push the cutting unit back onto the appliance (Fig. 17).

Replacement

Only replace a worn or damaged cutting unit with an original Philips cutting unit, available from authorised Philips service centre.

1. Press the release button. The cutting unit comes off the appliance (Fig. 14).
2. Insert the lug of the new cutting unit into the guiding slot and push the cutting unit onto the appliance (Fig. 17).

Ordering accessories
To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips dealer. You can also contact the Philips Consumer Care Center in your country (see the international warranty leaflet for contact details).

Disposal
This product may contain lead and mercury.
Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or visit www.recycle.philips.com.

Warranty and support

If you need information or support, please www.philips.com/support or call toll free: 1-866-800-9311.

Warranty restrictions

• Philips North America LLC (USA) and/or Philips Electronics Ltd (Canada) warrants its products for a period of two years after the date of purchase. If any defect due to faulty materials and workmanship occurs within this two-year warranty period, Philips North America LLC (USA) and/or Philips Electronics Ltd (Canada) will repair or replace the product at its expense.
• Philips North America LLC (USA) and/or Philips Electronics Ltd (Canada) will only pay for repair or replacement if convincing proof is provided, for instance by means of a receipt, that the day on which service is claimed is within the warranty period. Parts that are subject to wear (such as cutting units and shaving heads) are not covered by the terms of the international warranty.
• The warranty is not valid if a defect is due to damage caused by incorrect use, poor maintenance (e.g. parts blocked by scale) or if alterations or repairs have been carried out by persons not authorized by Philips North America LLC (USA) and/or Philips Electronics Ltd (Canada).
• For the appliance to be used correctly, the user should strictly adhere to all instructions included in the user manual and should abstain from any actions or uses that are described as undesired or which are warned against in the user manual.
• These warranty restrictions do not affect your statutory rights.

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you are unable to solve the problem with the information below, visit www.philips.com/support for a list of frequently asked questions or contact the Consumer Care Center in your country.

always fully in contact with the skin when you move the appliance through the hair.
| You only move the appliance in one direction.| Because not all hairs grow in the same direction, move the appliance in different directions (upwards, downwards and across).
| The setting of the comb has changed during trimming.| Check the setting of the comb. If you push the appliance too hard onto the scalp, you may accidentally change the setting of the comb.
| The comb is not assembled correctly.| Detach the comb and reattach it.
| The cutting performance decreases when the cutting unit and the comb are dirty.| Clean the cutting unit and the comb (see ‘Cleaning’).
The appliance does not work when I switch it on.| The appliance is not connected to the the wall socket..| Insert the small plug into the appliance and put the supply unit in the wall socket (Fig. 4).

© 2018 Koninklijke Philips N.V.
All rights reserved
4222.002.9134.1 (24/8/2018)

References

• Philips Customer Service Support - Home | Philips
• Product registration | Philips
• Philips - United States | Philips

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>