marta MT-HP4232A Electric Stove User Manual
- June 16, 2024
- MARTA
Table of Contents
marta MT-HP4232A Electric Stove
Specifications
- Model: MT-HP4232A
- Power Supply: 220-240V ~ 50/60Hz
- Maximum Power Consumption: 400W
- Manufacturer: Cosmos Far View International Limited
- Manufacturer Address: Room 701, 16 apt, Lane 165, Rainbow North Street, Ningbo, China
Product Usage Instructions
Important Safety Instructions
- Before using the electric stove, read and follow all safety instructions provided in the user manual.
FAQ
- Q: What should I do if the electric stove displays Warning Signal E0?
- A: Check whether the plug is properly switched on before using the stove.
- Q: How can I address Warning Signal E5 on the electric stove?
- A: Warning Signal E5 indicates that the IGBT temperature has reached a very high level. Allow the stove to cool down before using it again.
Parts list
- Body
- Plate
- Control panel
The real set of the appliance could be different from those listed in the User manual. Check once buy.
USER MANUAL
IMPORTANT SAFETY INSTRUCTIONS
- Read these instructions carefully before using the device and save them for future reference. The appliance is intended only for cooking.
- Before switching on for the first time, check whether the power supply of the product indicated in the technical data table corresponds to the power supply in your local network.
- Use only for domestic purposes, according to this operating manual. The device is not intended for industrial use.
- Do not use outdoors.
- Always disconnect the appliance from the mains before cleaning, or if you do not use it.
- When disconnecting the device from the power supply, do not pull the power cord, only hold the plug.
- To avoid electric shock and fire, do not immerse the device in water or other liquids, and do not install the device on a wet surface, or near water. If this happens, disconnect it from the power supply immediately and contact the service centre for verification.
- Avoid simultaneous use of this appliance with other high-power electrical appliances.
- To avoid a short circuit, clean the appliance regularly, and avoid insects getting inside.
- Use only dishes that are resistant to high temperatures for cooking.
- Do not use the device in places where children can easily come into contact with the device. NEVER allow children to operate the device on their own.
- Never leave the appliances unattended while using them. Overheating leads to the formation of smoke and greasy spots that can ignite.
- Do not place items on the plate after heating until the plate has cooled down, as non-heat-resistant items can easily burn or melt.
- Do not touch the stove until the heating warning indicator goes out. The flashing overheating warning indicator indicates that the temperature of the heating zone of the stove is too high to touch. As soon as the temperature cools down to a safe level, the overheating warning indicator will automatically turn off.
- Do not turn off the power until the overheating warning light goes out to prevent any accidents or injuries.
- Do not connect the plug to an electrical outlet to which several other electrical appliances are also connected.
- Do not cook on a broken or cracked hob. If the surfaces of the hob are cracked, immediately unplug the appliance from the electrical outlet and contact a qualified technician.
- Do not modify parts or repair the device yourself.
- Do not use the device near a fire or wet places.
- Do not install the device on unstable surfaces.
- Do not move the appliance when there is a pan or baking tray on it.
- Do not heat the pan empty and do not overheat it.
- Use the device so that there is enough space around it. For optimal and safe operation, the device must be placed at least 10 cm away from the wall. Make sure that there are no obstacles on the front side, as well as on the right or left side of the device.
- Do not use the device on a carpet, tablecloth or any other products with low-temperature resistance.
- Do not block the air intake or exhaust outlet.
- Do not touch the top plate immediately after removing the pan or pan, as the top plate will still be very hot.
- Do not use the device with a broken or damaged power cord. Contact a qualified specialist for inspection or repair, or contact the manufacturer.
- Unplug the device from the wall outlet before cleaning or maintenance.
- Allow the device to cool completely before cleaning.
- Use only a mild detergent to remove dirt.
- Do not immerse the device under running water to avoid malfunctions.
- Before cooking, make sure that the ceramic dishes are clean, otherwise, it may be difficult to wash off dirt and soot, and the dishes may discolour.
- Do not use abrasive or aggressive cleaning agents for the device, as they can damage the stove as a result of a chemical reaction.
- Do not use gasoline, thinner, hard cleaning brush or polishing powder to clean the cooker to avoid damaging the exterior finish.
- Persons with pacemakers should be at least 60 cm away from the working stove.
- Failure to follow these recommendations may result in electric shock or death.
- The device is not intended for use by people with physical and mental disabilities who have no experience with this device. In such cases, the user must be previously instructed by the person responsible for his safety.
CLEANING AND MAINTENANCE
- Unplug the appliance from the power supply before cleaning.
- Let the unit cool down completely.
- Wipe external surfaces with a damp cloth with some washing-up liquid. Do not use abrasive detergents, any organic solvent or aggressive chemicals.
ERROR MESSAGES
Errors| Check whether the plug is switched on.
Check whether the electricity is cut off.
---|---
Warning Signal E0| Check whether a suitable pot is used.
Check whether the pot is put on the cooking plate
Warning Signal E1| Check whether the IGBT probe breaks off.
Warning Signal E2| Check whether the IGBT temperature reaches very high.
Warning Signal E3| Check whether the voltage is too high.>280V
Warning Signal E4| Check whether the voltage is too low. <85V
Warning Signal E5| Check whether the main temperature sensor breaks off.
Warning Signal E6| Check whether the cooker is dry-burning.
Warning Signal E9| Check whether the errors are on the circuit.
WARRANTY
WARRANTY DOES NOT COVER SUPPLIES (filters, ceramic and non-stick coating, rubber seals, etc.) The production date is available in the serial number located on the identification sticker on the gift box and/or on the sticker on the device. The serial number consists of 13 characters, the 4th and 5th characters indicate the month, and the 6th and 7th indicate the year of device production. Producer may change the complete set, appearance, country of manufacture, warranty and technical characteristics of the model without notice. Please check when purchasing a device. Current information about service centres is available on the website https://multimarta.com/.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>