Exoton S-1202 Series Baron 400W Powered 6 Channel Mixer User Manual

: June 13, 2024
: Exoton

Table of Contents

Exoton S-1202 Series Baron 400W Powered 6 Channel Mixer
Product Usage Instructions
FAQ
IMPORTANT SAFETY INSTRUCTIONS
INTRODUCTION
FRONT PANEL SECTION FEATURES
CONNECTIONS
CONNECTING WITH BLUETOOTH
Documents / Resources

Exoton S-1202 Series Baron 400W Powered 6 Channel Mixer

Specifications

Product Name: S-1202 BARON SERIES 400W Powered 6 Channel Mixer
Power Output: 400W
Channels: 6

Product Usage Instructions

Important Safety Instructions

Do not remove the cover or back of the mixer.
Refer servicing only to qualified personnel.
Avoid exposing the mixer to rain or moisture.
Do not perform any procedures not specified in the manual.

Introduction

Congratulations on your purchase of the S-1202 BARON Series Powered 6-Channel Mixer.
The mixer is designed for parties, meetings, and indoor, or outdoor performances with an impact-resistant design made of durable polypropylene.

Front Panel Section Features

MIC INPUT: Accepts balanced low-impedance input signals with Phantom power (15 volts) for condenser microphones.
BALANCED INPUT (LINE): Accepts balanced high impedance input signals through a standard 1/4″ jacks connector.

Connections

When making connections with the mixer, ensure to use the correct cables and follow these guidelines.
Use mono 1/4″ plugs for unbalanced equipment connected to balanced inputs/outputs.
Connect headphones following the Tip= Left signal, Ring= Ring signal, Sleeve= Ground/shield configuration.
For power output connections, use Tip= Out, Sleeve= Out configuration.

FAQ

Q: Can I connect passive speakers to the S-1202 BARON SERIES mixer?

A: Yes, you can connect passive speakers to the mixer. Refer to section 4.2 in the manual for detailed instructions on connecting the mixer to passive speakers.

Q: How do I purchase additional gear and accessories for the mixer?

A: To purchase additional gear and accessories, follow the guidelines provided in section 5.0 of the user manual.

IMPORTANT SAFETY INSTRUCTIONS

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE THE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED PERSONNEL
The lightning flash with the arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operat-ing and maintenance (servicing) instructions in the literature accompanying the appliance.
WARNING: To reduce the risk of electric shock, do not remove the cover (or back). No user-serviceable parts inside.
Refer servicing to qualified service personnel.
To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture
CAUTION: Use of controls or adjustments or performance of procedures other than those specified may result in a hazard.

Read these instructions before operating this apparatus.
Keep these instructions for future reference.
Heed all warnings to ensure safe operation.
Follow all instructions provided in this document.
Do not use this apparatus near water or in locations where condensation may occur.
Clean only with a dry cloth. Do not use aerosol or liquid cleaners. Unplug this apparatus before cleaning.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
Protect the power cord from being walked on or pinched particularly at plug, convenience receptacles, and the point where they exit from the apparatus.
Unplug this apparatus during lightning storms or when unused for long periods.
Refer all servicing to service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.
When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.
When unplugging the product from a main outlet, always pull the plug, never the lead.
Don’t repeatedly switch the product on and off. This shortens the life of the product.
Keep the product out of the reach of children or pets. Do not leave the product unattended.

INTRODUCTION

Congratulations on your purchase of the S-1202 BARON Series Powered 6-Channel Mixer EXOTON BARON series has an attractive impact-resistant design.
The molded enclosure is made of highly durable polypropylene, which is designed for parties, meetings, and indoor or outdoor performances.
FCC ID: 2AWLTYANKA2020

POWERED MIXER

6-channel powered mixer features bluetooth function to instantly pair with iPhone, iPad, Android devices, etc, within line of sight of up to 66 feet. No cables are needed!
Built-in USB drive interface: Simply insert a USB drive to play back songs. You can also connect the PC to the port directly to playback MP3 files.
6.35mm&XLR MIC input + RCA Inputs & outputs: Mic inputs are compatible with condenser mic/dynamic mic/guitars. Press the +48V phantom button to switch. Each channel has individual volume controls. 5-band equalizer, effect controller;
Easy to transport and set up: Ergonomically shaped side handles for easy carrying and setup. Comes with a mounting accessory to connect to a mixer rack on the market.

FEATURES

6 mono Mic inputs with XLR jacks
6 ¼” line inputs(CD, Tuner, Tape Deck Etc)
Individual control for each channel
Line out for external amplifier or recording device BLUETOOTH 5.1
USB Port input with blue LCD
Remote control included
Shielded internal power supply

FRONT PANEL SECTION FEATURES

MIC INPUT
- Electronic Balanced inputs were acceptable for a standard XLR male connector. It is designed to accept a balanced low-impedance input signal, Phantom power(15 volts) for condenser microphones is always on and available.
- It has an input impedance of 1K ohm The connector is wired as: A pin-shield: Pin3-negative(cold).
BALANCED INPUT(LINE)
- Electronic Balanced inputs are acceptable as a standard 1/4*jacks connector. It is designed to accept a balanced high-impedance input signal
GAIN
- This is a function to adjust the volume of a signal connection into each channel and adjust the volume of output, together with the master fader.
EFFECT
- This is a send control to the reverb bus. It controls the amount of reverberation added to the input signals.
TREBLE
- This control gives you up to 15 db of boost or cut at 10 kHz and above, and it is also flat at the detent. Use it to add sizzle to cymbals, and an overall sense of transparency or edge to keyboards, vocals, guitar, and bacon frying.
- Turn it down a little to reduce sibilance, or to hide tape hiss.
BASS
- This control gives you up to 15 dB boost or cut at 100Hz and below, This circuit is flat (no boost or cut)at the center detent position. This frequency represents the punch in bass drums, bass guitar, fat synth patches, and some really serious male singers.
EFF VOL
- Using this control, you can adjust the signal level of total reverb
ECHO
- Using this control, you can adjust the signal level of the echo output.
DELAY
- Using this control, you can adjust the delay time interval of echo repeat.
GRAPHIC EQUALIZER
- A 5-band equalizer is provided for sound control over each frequency, and precise high-quality sound by final tone control(60,250,1K,2K,8KHz shelving at+/-12dB)
RCA TAPE IN
- The TAPE IN allows cassette recorders or CD players to be added to the Main output.
AUX IN
- Auxiliary 3.5mm input connector
RCA RECORD OUT
- The RECORD OUTPUT, with TAPE RCA jacks, provides signal output to a cassette deck or Home audio equipment.
TAPE
- This controls the level of the playback inputs(RCA) jack.
MP3 SYSTEM INSTRUCTIONS
- Press once to play a song or pause while playing a song (MP3 mode).
- Press and hold on for three seconds to inset the Reader Folder mode.
- Press to scan all FM channels then store (FM radio mode).
- Press once to jump next mode. We provide 4 modes (FM Radio， MP3, Bluetooth. Reader Folder).
- It is a repeat button. We provide 3 modes, Repeat one, Repeat all, and Random. Press once to jump next mode
- Long press and enter the folder mode.
- Press once to jump to the previous song or FM channel. Press and hold to decrease the volume level, Press once to jump previous folder when in Folder mode.
- Press once to jump next song or FM channel, Press and hold to increase the volume level. Press once to jump next song or FM channel, Press and hold to increase the volume level.
- Press the button to switch the scene mode. Press this button in the Bluetooth mode for 3-5 seconds to enter the TWS pairing mode.
- Ir window for remote control.
MP3 VOLUME CONTROL
POWER LED
- It lights when the power switch turns on.
OUTPUT LEVEL INDICATOR
- This is a level meter that shows output levels.
PHANTOM POWER SWITCH AND PHANTOM LED
- When you press the switch the XLR input will have 15V The LED +15V will be turned on when start working. 20、MASTER VOLUME
- Using this control, you can adjust the signal level of the main channel.
EXTERNAL EFFECT JACK
- The signal is output from the SEND jack to the external effector and the processed signal is connected to the RETURN jack
SPEAKER OUTPUT
- These are 2 conductor SPEAKON speaker outputs. Each one is rated at 8 ohm minimum impedance. The total minimum load to the amplifier is 4 ohms.
- You may connect either 1pc 4 ohm speaker, 1pc 8 ohm speaker, or 2pcs 8 ohm speaker cabinets.
- Do not below-rated minimum impedance.
3 PIN AC JACK
POWER SWITCH
- Turns the unit ON or OFF. Always turn level controls down before turning on the unit
Power transfer switch, 115/230V conversion

CONNECTIONS

You will need a lot of cables for different purposes – see the following figures to make sure you have the right cables.
Unbalanced equipment may be connected to balanced inputs/outputs. Either use mono 1/4 ” plugs or connect the ring and sleeve of TRS plugs.

CONNECTING WITH BLUETOOTH

Activate the BT function on your device (Mobile phone, tablet, etc.) from which you want to play the music. See the operating instructions for that device.
Press the “1” button and activate the BT function.
Select the Bluetooth name “EXOTON” on your device to connect.

MIXER CONNECTED TO PASSIVE SPEAKERS

S-1202 MIXER SIZE

TO PURCHASE ADDITIONAL GEAR AND ACCESSORIES

To purchase EXOTON’s other products, please contact us at support@exotonaudio.com
For our other product list please visit: https://exotonaudio.com. You can also contact us directly through Amazon and we will help you find the item you want.

SERVICE AND REPAIR

For spare parts, service, and maintenance, please contact us at support@exotonaudio.com to purchase additional replacement parts or for other maintenance-related matters.
The company does not issue service manuals to users, and users are advised not to attempt any self-maintenance.
Because doing so would void all warranties. If you have any questions, also can visit our website to find the answers: https://exotonaudio.com.

WARRANTY INFORMATION

EXOTON is committed to providing the best warranty service for each product.
From the date of original purchase, EXOTON provides a warranty of three months for any material or workmanship problems arising out of strict compliance with the instructions.
EXOTON may repair the product within this warranty period. Please be sure to properly keep the “proof” of purchase products, to obtain warranty service.
Products without purchase certificates will not be accepted for return, and warranty service. The warranty service is limited to problems arising from normal use.
Users should strictly follow the instructions for correct use. Any wanton damage or unauthorized maintenance of the machine, accident, wrong use, human negligence, etc., will not be accepted by the warranty scope.
In addition, the guaranteed repair is only valid for purchase in the Brand’s Amazon store or brand website store. If you have other questions, please visit https://exotonaudio.com.

CUSTOMER SERVICE AND TECHNICAL SUPPORT

You are welcome to visit our website at https://exotonaudio.com.
From this website, you can get answers to frequently asked questions, technical guidance, return instructions, and other helpful information.
We do our best to respond to your inquiry within one business day.
EXOTONhttps://exotonaudio.com
https://www.ExotonAudio.com

Documents / Resources

| Exoton S-1202 Series Baron 400W Powered 6 Channel Mixer [pdf] User Manual
S-1202 Series Baron 400W Powered 6 Channel Mixer, Baron 400W Powered 6 Channel Mixer, Powered 6 Channel Mixer, Channel Mixer
---|---