Leiblsufo Pull Up and Dip Station Dip Stand Power Tower Instruction Manual
- June 11, 2024
- Leiblsufo
Table of Contents
Pull-up device
Instructional Manual
Pull Up and Dip Station Dip Stand Power Tower
Directions (Please read the Instruction manual before use)
Thank you for purchasing the pull-up device. In order to use the product correctly, please read the Instruction manual carefully.
- Please follow the installation method in the Instruction manual and assemble correctly.
- It takes about 50 minutes to assemble.
- Please check all parts carefully and make sure the belt is firmly fixed before use.
- Equipment should be checked regularly. When the parts are abnormal or loose, they must be repaired in time.
- Please place the equipment on the level ground. Make sure there are no sharp tools around.
- Please follow the coach’s instructions.
- Do not use for pregnant women, patients with heart disease or hypertension.
A. Training time and times vary from person to person, please make reasonable
arrangements.
B. When using, avoid dangerous actions and wrong methods of use
C. If discomfort occurs during use, please stop use and seek medical advice
immediately.
Special precautions
Picture Ais the correct pull-up motion.
Picture B is the wrong pull-up motion.
The wrong action may cause the equipment to tilt violently, or even cause
accidental overturning, so do not carry out dangerous action.
Name of each part
Assembly Sequence 1
- Please use four screws (a) to assemble left and right support base(7) and main support bracket(1)
- Insert the screw from the bottom, put the large washer down and put the small washer on top.
Pay attention: Please do not tighten the screw first
Assembly Sequence 2
Please use four screws (a) and four screws (b) to assemble support lever(4)
and main support bracket(1) .
Pay attention: Please do not tighten the screw first
Assembly Sequence 3
- Please use four screws(a)to assemble Connecting lever(5)and main support bracket(1)
- Please place the large washer outside.
Pay attention: Please do not tighten the screw first
Assembly Sequence 4
- Please use two screws(c) to assemble Backrest lever(3) and main support bracket(1).
Pay attention: Please do not tighten the screw first
Assembly Sequence 5
Please Insert Height adjusting lever(2) into the main support bracket(1).
Assembly Sequence 5
- Assemble Horizontal bar(5) and Height adjusting lever(2) with screws(d)
Pay attention: In terms of the assembly sequence, awasher must be used and placed underneath.
Assembly sequence 7
- Adjust Height adjusting lever(2) to the desired height and fix it with the adjustable screws(e)
Pay attention: Tighten all screws.
So assembly was completed
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>