Leiblsufo B0BM5T19LX Power Tower Dip Station Height Adjustable Exercise Equipment Instruction Manual
- June 1, 2024
- Leiblsufo
Table of Contents
Leiblsufo B0BM5T19LX Power Tower Dip Station Height Adjustable Exercise Equipment
Thank you
Thank you for purchasing the pull-up device . In order to use the product correctly, please read the Instruction manual carefully.
- Please follow the installation method in the Instruction manual and assemble correctly.
- It takes about 50 minutes to assemble.
- Please check all parts carefully and make sure the belt is firmly fixed before use.
- Equipment should be checked regularly. When the parts are abnormal or loose , they must be repaired in time.
- Please place the equipment on the level ground. Make sure there are no sharp tools around.
- Please follow the coach’s instructions.
- Do not use for pregnant women, patients with heart disease or hypertension.
A Training time and times vary from person to person, please make reasonable arrangements.
B When using, avoid dangerous actions and wrong methods of use
C If discomfort occurs during use, please stop use and seek medical advice immediately.
Special Precautions
Picture A is the correct pull-up motion Picture Bis the wrong pull-up motion.
The wrong action may cause the equipment to tilt violently, or even cause
accidental overturning , so do not carry out dangerous action.
Name Of Each Part
-
Main support bracket
-
Height adjusting lever
-
Backrest lever
-
Support lever
-
Connecting lever
-
Horizontal bar
-
Left and right support base
a. 10*25 12 Screws with washer
b. with arch washer
c. 2 Screws
d. 8*85
2 Screws tools
e. 4 adjustable Screws
Assembly Instructions
-
Assembly sequence 1
-
Please use four screws (a) to assemble left and right support base(?) and main support bracket (1)
-
Insert the screw from the bottom, put the large washer down and put the small washer on top.
Pay attention: Please do not tighten the screw first.
-
Assembly sequence 2
Please use four screws (a) and four screws (b) to assemble support lever(4) and main support bracket(1).
Pay attention: Please do not tighten the screw first.
-
Assembly sequence 3
-
Please use four screws(a)to assemble Connecting lever(S)and main support bracket( 1)
-
Please place the large washer outside.
Pay attention: Please do not tighten the screw first.
-
Assembly sequence 4
-
Please use two screws(c) to assemble Backrest lever(3) and main support bracket(1 ).
Pay attention: Please do not tig1hten the sere first
-
Assembly sequence 5
Please Insert Height adjusting lever(2) into the main support bracket( 1 ).
-
Assembly sequence 6
-
Assemble Horizontal bar(5) and Height adjusting lever(2) with screws( d).
Pay attention: In terms of the assembly sequence, a wash er must be used and placed underneath.
-
Assembly sequence 7
-
Adjust Height adjusting lever(2) to the desired height and fix it with the adjustable screws( e)
Pay attention: Tighten all screws. So assembly was completed.
Email: 1251826058@qq.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>