Koala Kare KB208 Replacement Shock Installation Guide
- June 10, 2024
- Koala Kare
Table of Contents
Koala Kare KB208 Replacement Shock
Product Information
Specifications
- Model : KB208
- Product Type: Replacement Shock Kit
- Manufacturer: Koala Kare Products, a Division of Bobrick
Tools Needed
P/N 873-KIT, Flat Head Screwdriver, 7/16 Wrench or Socket Wrench
Product Usage Instructions
-
Step 1: Locate the Shock
Remove the baby changing station from the wall. Turn the unit over so that you can access the shock on the rear of the station. At the top of the gas shock there is a “C” clip that holds the shock onto the ball stud. To remove the gas shock carefully slide a flat head screwdriver in-between the shock and the “C” clip. Once the tension on the “C” clip is removed you will be able to pull the gas shock off the ball stud. Fig. 1, 2. -
Step 2: Gather Tools
The lower part of the shock is attached to the unit by a 3½” bolt.The head of the bolt and nut require 7/16″ wrench or socket wrench to remove them. Once the nut is removed from the bolt you will be able to remove it from the lower tab on the shock. The hole on the tab is designed to be a snug fit so it may require some force to slide it off. Fig. 3, 4. -
Step 3: Remove Old Shock
Take the new shock and insert the bolt through the tab. Secure the bolt using the nut and washer. Ensure that everything is in the same locations as they were before you removed the old shock. -
Step 4 : Install New Shock
With the unit on the ground, compress the shock until you can align the head of the shock with the ball stud and push the head of the shock onto the ball stud. Make sure the head is secure by twisting it from side to side.. -
Step 5: Test the Replacement
Open and close door of unit several times to make sure that the shock is functioning properly. Remount unit following the proper installation instructions that were provided with the unit.
Contact Information
- Koala Kare Products, A Division of Bobrick
- Address : 6982 South Quentin Street, Centennial, CO 80112-3945
- Main : 303.539.8300
- Toll Free: 888.733.3456
- Fax: 303.539.8399
- Website : koalabear.com
- Email : customerservice@koalabear.com
FAQ
Q: Can I use any shock replacement kit for my Koala Kare product?
A: It is recommended to use the specified replacement shock kit (P/N 873-KIT)
to ensure compatibility and proper functioning with your Koala Kare product.
Q: How often should I replace the shocks on my Koala Kare product?
A: The replacement frequency may vary based on usage and wear. It is advisable
to inspect the shocks periodically and replace them as needed to maintain
optimal performance.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>