Ruijie EG105GWX All-In-One Wireless Router User Manual

Ruijie EG105GWX All-In-One Wireless Router

User Manual
Note The device and software will be upgraded constantly. Please contact Ruijie technical support for details.

Preparing for Installation

Darkano Contents (The Ethernet cables are customer-unlined )

Product Appearance

Front Panel

Note:

1. Mesh Button (Press for 2 seconds to perform Mesh pairing.
2. Mesh LED 3 System Status LED

Note:

1. Power Plug
2. Reset Button (Press for less than 2 seconds to reboot the router. Press for more than 5 seconds to restore the router to factory settings.
3. USB Port
4. LAN Port
5. LAN/WAN Switchable Port
6. WAN Port

Installing the Router

1. Installing the Router You can install the router on a workbench or wall.

   • Installing the Router on a Workbench Place the router on a workbench and maintain a proper clearance around the device for heat dissipation.
   • Installing the Router on a Wall Drill two holes on the wall.
   • The holes should be level with each other and their centers should be 252.2 mm (9.93 in.) apart. Tap the two expansion anchors into the holes and drive two screws into the expansion anchors.
   • Note: If the router is installed on a wall, the expansion anchors and screws are customer-supplied.

2. Connecting the Cables Connect the power supply to the power plug on the router with a power cord. Connect the WAN port (yellow) on the router to the Internet with an Ethernet cable.

3. Power Plug: 100 V AC to 240 V AC

4.  WANO: Connect the WANO port to the Internet.

5. LANO-LAN3: Connect the LANO-LAN3 ports to the switch, the access point or other network devices with an Ethernet cable.
   (Note: If the LAN port is connected to the AP directly, an extra power supply is required for the AP.)

6. Powering on the Router|
   Connect the power adapter to the router after verifying that the router is correctly installed and the cables are properly connected. When the system status LED is solid on, perform configuration on the router.

LED

Network Configuration Method

(Recommended) Scan the QR code in the manual or on the device to download the Ruijie Reyee APP. Perform the intelligent networking and complete the network configuration based on the instructions on the APP.

Method 2
Connect the PC to the SSID (default: @Ruijie-XXXXX) broadcast by the router or connect the PC to the LAN port (blue) of the router with an Ethernet cable. Please visit http://192.168.110.1 by browser to perform configuration. (Google Chrome browser is recommended.

FAQ

• Q: How can I restore the device to factory settings?
  A: Power on the router and wait for 2 to 3 minutes until the device is started up. Press and hold the Reset button on the router for over 5 seconds until the system status LED is fast blinking, and then release the button. After the system status LED is solid on, the router will broadcast the SSID @Ruijie- XXXXX, indicating that the router is restored to factory settings.

• Q: Can I connect multiple routers with the Ethernet cables?
  A: Yes. The wired connection is more stable. Connect one end of the Ethernet cable to the WAN port (yellow) of the secondary router and connect the other end to the LAN port (blue) of the primary router.

References

• csm
• csm
• Ruijie Community
• Ruijie Community
• Ruijie Reyee - Redefine your easy network
• Support Center - Ruijie Reyee

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>