NEXTIVITY CEL-FI GO G43 Commercial Cell Phone Signal Booster User Guide
- June 10, 2024
- NEXTIVITY
Table of Contents
**NEXTIVITY CEL-FI GO G43 Commercial Cell Phone Signal Booster User Guide
**
Product Using Instruction
CAUTION
-
Use CEL-FI GO G43 indoors. It should not be used outdoors.
-
The donor antenna(s) MUST be installed to ensure a minimum of 25.5 in (65 cm) separation distance from human body at all times.
-
The server antenna(s) MUST be installed to ensure a minimum of 8 in (20 cm) separation distance from persons from human body at all times.
-
These products are designed to be used with a direct plug-in power supply unit. When installing the
equipment, all the requirements of the manufac turer and the referenced standards must be met. -
There are no user-serviceable parts inside.
-
Changes or modifications to this product not expressly approved by Nextivity may void your right to operate the equipment. There are no user-serviceable parts inside.
-
Only the antennas listed or approved by the manu facturer can be used with CEL-FI GO G43. This device may be operated ONLY in a fixed location for in-building use.
-
Use of unauthorized antennas, cables, and/or coupling devices not conforming with ERP/EIRP and/or indoor- only restrictions is prohibited.
Limitation of Liability
In no event shall NEXTIVITY, nor its directors, employees, agents,
suppliers or End Users, be liable under contract, tort, strict liability,
negligence or any other legal or equitable theory with respect to the Products
or any other subject matter of this Agreement (i) for any lost profits, cost
of procurement of substitute goods or services, or special, indirect,
incidental, punitive, or consequential damages of any kind whatsoever or (ii)
for any direct damages in excess of (in the aggregate) the fees actually
received by NEXTIVITY from End User with respect to the Products actually
purchased and paid for.
WARNING
E911 location information may not be provided or may be inaccurate for calls
served by using this device.
Regulatory Information: US FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Regulatory Information: Canada CAN ICES-3 (B)/NMB-3
This is a CONSUMER device. BEFORE USE, you must meet all requirements set out
in CPC-2-1-05. This device MUST ONLY be operated with approved antennas and
cables as specified by the manufacturer. The donor and server antenna(s) of
this device MUST be installed to always ensure a minimum of 25.5 in (65 cm)
and 8 in (20 cm) separation distance from the human body respectively. To
reduce oscillations, sufficient separation.
CAUTION
- Use CEL-FI GO G43 indoors. It should not be used outdoors.
- The donor antenna(s) MUST be installed to ensure a minimum of 25.5 in (65 cm) separation distance from human body at all times.
- The server antenna(s) MUST be installed to ensure a minimum of 8 in (20 cm) separation distance from persons from human body at all times.
- These products are designed to be used with a di- rect plug-in power supply unit. When installing the equipment, all the requirements of the manufacturer and the referenced standards must be met.
- There are no user-serviceable parts inside.
- Changes or modifications to this product not expressly approved by Nextivity may void your right to operate the equipment. There are no user-serviceable parts inside.
- Only the antennas listed or approved by the manu- facturer can be used with CEL-FI GO G43. This device may be operated ONLY in a fixed location for in-building use.
- Use of unauthorized antennas, cables, and/or coupling devices not conforming with ERP/EIRP and/or indoor- only restrictions is prohibited.
Limitation of Liability
In no event shall NEXTIVITY, nor its directors, employees, agents,
suppliers or End Users, be liable under contract, tort, strict liability,
negligence or any other legal or equitable theory with respect to the Products
or any other subject matter of this Agreement (1) for any lost profits, cost
of procurement of substitute goods or services, or special, indirect,
incidental, punitive, or consequential damages of any kind whatsoever or (ii)
for any direct damages in excess of (in the aggregate) the fees actually
received by NEXTIVITY from End User with respect to the Products actually
purchased and paid for.
WARNING
E911 location information may not be provided or may be inaccurate for calls
served by using this device.
Regulatory Information: US FCC Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is con- nected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Regulatory Information: Canada CAN ICES-3 (B)/NMB-3
This is a CONSUMER device. BEFORE USE, you must meet all requirements set out
in CPC-2-1-05. This device MUST ONLY be operated with approved antennas and
cables as specified by the manufacturer. The donor and server antenna(s) of
this device MUST be installed to always ensure a minimum of 25.5 in (65 cm)
and 8 in (20 cm) separation distance from the human body respectively. To
reduce oscillations, sufficient separation distance is recommended between the
donor and server antennas of the zone enhancer system. You MUST cease
operation of this device immediately if requested by ISED or a licensed
wireless service provider.
WARNING : E911 location information may not be provided or inaccurate for
calls served by this device.
This device complies with Industry Canada license- exempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
Safe Disposal of WEEE
Waste electrical and electronic equipment (WEEE) must not be disposed of in normal refuse. At the end of its life take this CEL-FI Smart Signal Booster to a local authority recycling centre or other safe location for the disposal of waste electrical and electronic products.
- Trademark
CEL-FI, Intelliboost, and the Nextivity logo are trademarks of Nextivity, Inc.
Patents
This product is covered by Nextivity, Inc., US patents and patents pending. Please refer to http://www.nextivityinc. com for details.
Copyright
Copyright© 2023 by Nextivity, Inc. All rights reserved. Reproduction or media conversion by any means is protected by copyright and may only occur with prior written permission of Nextivity. Designed by Nextivity in California. distance is recommended between the donor and server antennas of the zone enhancer system. You M U ST cease operation of this device immediately if requested by ISED or a licensed wireless service provider.
WARNING: E911 location information may not be provided or inaccurate for calls served by this device.
This device complies with Industry Canada license- exempt RSS standard(s). Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
Safe Disposal of WEEE
Waste electrical and electronic equipment (WEEE) must not be disposed of in
normal refuse. At the end of its life take this CEL-FI Smart Signal Booster to
a local authority recycling centre or other safe location for the disposal of
waste electrical and electronic products.
Trademark
CEL-FI, Intelliboost, and the Nextivity logo are trademarks of Nextivity, Inc.
Patents This product is covered by Nextivity, Inc., US patents and patents
pending. Please refer to http://www.nextivityinc.com for details.
Copyright
Copyright © 2023 by Nextivity, Inc. All rights reserved. Reproduction or media
conversion by any means is protected by copyright and may only occur with
prior written permission of Nextivity. Designed by Nextivity in California.
Warranty
Nextivity, Inc. provides a limited warranty for its products. For details, please refer to nextivityinc.com/warranty/.
This is a CONSUMER device.
This device may be operated ONLY in a fixed location. BEFORE USE , you
MUST REGISTER THIS DEVICE with your wireless provider and have your
provider’s consent. Most wireless providers consent to the use of signal
boosters. Some providers may not consent to use this device on their network.
If you are unsure, contact your provider. In Canada, BEFORE USE , you must
meet all requirements in ISED CPC-2-1-05. You MUST operate this
device with approved antennas and cables as specified by the manufacturer.
Donor Antennas MUST be installed at least 26 in (65 cm) from any person.
Server Antennas MUST be installed at least 8 in (20 cm) from any person. You
MUST cease operating this device immediately if requested by the FCC (or
ISED) or a licensed wireless service provider. WARNING. E911 location
information may not be provided or may be inaccurate for calls served by this
device.
U.S. Headquarters : Nextivity, Inc.
16550 West Bernardo Drive, Bldg. 5, Suite 550
San Diego, CA 92127, USA
Phone: +1 858.485.9442 •
www.nextivityinc.com
Nextivity UK Ltd
Unit 9, Basepoint Business Cen tre Rivermead Drive, Westlea Swindon SN5
7EX
Nextivity Singapore Pte. Ltd.
2 Changi Business Park Avenue 1, Level 2 – Suite 16, 486015 Singapore
Bureau in Europe Union
Carrer Bassols 15-1, Bacelona 08026, Spain
legal_go-g43_eng_23-0925
Nextivity UK Ltd
Unit 9, Basepoint Business Centre Rivermead Drive, Westlea Swindon SN5 7EX
Nextivity Singapore Pte. Ltd.
2 Changi Business Park Avenue 1, Level 2 – Suite 16, 486015 Singapore
Bureau in Europe Union
Carrer Bassols 15-1, Bacelona 08026, Spain
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>