PROGRESS LIGHTING P300455 Rectangular Frameless Bathroom Vanity Mirror Instruction Manual
- June 9, 2024
- PROGRESS LIGHTING
Table of Contents
PROGRESS LIGHTING P300455 Rectangular Frameless Bathroom Vanity Mirror
PART DESCRIPTION
- Mirror Frame: 1
- Mirror Face: 1
HARDWARE CONTENTS (not actual size)
Safety Information
Please read and understand this entire manual before attempting to assemble, operate or install the product.
CAUTION: Read instructions carefully and turn electricity off at main circuit breaker panel before beginning installation. CAUTION: Risk of fire. Min. 90°C supply conductors. Consult a qualified electrician to ensure correct branch circuit conductor. WARNING: If any Special Control Devices are used with this fixture, follow instructions carefully to assure full compliance with N.E.C. requirements. If there are any questions, contact a qualified electrical contractor.
CAUTION: All glass is fragile. Use care when handling glass shades and bulbs.
THIS PRODUCT MUST BE INSTALLED BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED, IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE. KEEP THESE INSTALLATION INSTRUCTIONS
Preparation
- Before beginning installation, make sure all parts are included using the contents diagrams from page 1. If any part is missing or damaged, do not attempt to assemble, install or operate the product.
- Estimated assembly time: 30 minutes.
- Tools required for assembly (not included): screwdriver, pliers, wire stripper, safety glasses, electrical tape, ladder, drill.
Care and Maintenance
Shut off main power supply before cleaning product or changing light bulbs. To clean, wipe with damp cloth. Do not use abrasive cleaners or cleaners that contain alcohol.
Assembly Instructions
-
Remove the mirror face (B) from the mirror frame (A) by first sliding up then pulling off.
-
Place the mirror frame (A) against the wall and mark the position of the screw holes through the mirror frame (A) on the wall. Ensure that the mirror frame (A) is level.
Use a 15/64 inch drill bit to drill pilot holes at the locations marked and insert the wall anchors (BB). Screw the four pan head self tapping screws (AA) into the four wall anchors (BB).
-
Install a NM cable connector clamp (not included) into the mounting plate (not included). Pass the mirror jumper wire through the clamp and secure. Strip 3/8″ of insulation from the electrical wire ends. Using wire nuts (CC), connect the WHITE fixture wire to the WHITE supply wire from the outlet box; connect the BLACK fixture wire to the BLACK supply wire from the outlet box. Connect the fixture ground wire and supply ground wire using a wire nut or by fastening to the ground screw on the swivel mounting strap. Push all of the wire connections carefully into the outlet box. Install this assembly to the junction box using the mounting screws supplied with the junction box (not included).
-
Hang the mirror face (B) back onto the mirror frame (A).
Note: Be careful to make sure that the mirror face is properly seated on the mounting brackets before fully letting go of the mirror face.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>