KOBALT 19156 4-Drawer Steel Rolling Tool Cabinet Instruction Manual

ITEM #5071909
4-DRAWER
MOBILE CABINET
MODEL #19156
Español p. 11

KOBALT and logo design are trademarks or registered trademarks of LF, LLC. All rights reserved.
ATTACH YOUR RECEIPT HERE
Serial Number ————
Purchase Date ———–

PRODUCT SPECIFICATIONS

PACKAGE CONTENTS

HARDWARE CONTENTS (shown actual size)

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble or operate this product. Failure to follow may result in serious injury. Save all warnings and instructions for future reference.

WARNING

• Do not stand or step on this product. You may fall which may cause personal injury or product damage.
• When locking the product, close the drawers completely in order for the lock bars to work properly.
• Lock wheels when the product is not being moved.
• Secure this product properly before moving it with a forklift.
• Do not attach or mount this product to a vehicle. This may cause personal injury or product damage.

CAUTION

• Do not exceed the maximum drawer weight and total product weight, including contents. Always balance the cabinet load to avoid tipping. Place the heavier weights on the bottom drawers when possible.
• Be careful when opening more than one drawer. The product may become unstable and tip, which may also cause personal injury or product damage.
• Keep the product on level surfaces. The product may become unstable and tip if stored or moved on an unlevel surface, which may cause personal injury or product damage.
• Secure all items and lock all drawers before rolling this product. Only roll the product short distances by using the handle provided.
• Two people are needed to safely move this unit.
• Do not store liquids in the unit unless they are secured in an approved container.
• Keep children and bystanders away while loading, unloading, and moving the product.
• Always use common sense and be cautious when using this product. Do not modify this product in any way.

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package  contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 15 minutes (does not include unpacking time)
Tools Required for Assembly (included): 10 mm Wrench, 14 mm Wrench
Tools Required for Assembly (not included): Adjustable wrench

ASSEMBLY INSTRUCTIONS

1. Attach the cabinet handle (C) to the cabinet (A) using M6 x 20 mm bolts (AA).
   Note: The cabinet handle (C) can be attached to either side of the cabinet (A), but must match the end where the swivel casters with brake (D) will be installed. The holes in cabinet (A) are tapped and do not require nuts.
   
   Hardware Used

2. Ensure all cabinet drawers are securely locked into place using the lock (FF) and key (GG) on the cabinet (A). Lay the cabinet (A) on its back using the cardboard package materials to protect the finish. Mount the two swivel casters with brake (D) to the cabinet (A) using M8 x 25 mm bolts (BB), spring washer (CC) and washer (DD). Repeat this process for the fixed casters (E) on the opposite side of the cabinet (A). Return the cabinet (A) to its upright position.
   Note: Two people may be required to complete this installation. The swivel casters with brake (D) must be installed on the end of the cabinet (A) with the cabinet handle (C). Do not over tighten the screws.
   
   Hardware Used
   

3. If you plan to stack the chest (Item #5071908, sold separately) onto the cabinet (A), please follow the below step. Otherwise, forget this step. Remove the cabinet mat (B), unload the bottom drawers from the chest and the top drawer from the cabinet (A) using the method on Operating Instructions (Page 8). Insert M8 x 25 mm bolts (BB) from the bottom of the chest into the top of the cabinet (A) and tight with M8 nuts (EE). Install the 2 unloaded drawers back using the method on Operation Instructions (Page 8).
   Hardware Used
   

OPERATING INSTRUCTIONS

1. Using the caster brakes:
   To lock the swivel casters, step down on the levers marked with ON. To unlock casters, push down on the levers marked with OFF.
   Note: Be sure to lock both casters to prevent cabinet from rolling or swiveling.

2. Removing the drawers:
   Fully empty and extend the drawer. Push up the release lever on the one side of drawer slide while pulling down on the other release lever. Pull the drawer outward until it is released from the slides.
   

3. Re-inserting the drawers:
   Pull the slides and slide carrier out until fully extended. Hold the slide on the drawer while aligning it with the slide on the cabinet. Slightly insert one side and repeat for the other side. Slowly push the drawer until it is fully closed to engage the slide. Open and close the drawer to verify proper operation.
   

CARE AND MAINTENANCE

• Keep the product in good repair by adopting a regular maintenance program.
• The use of drawer liners (included) is recommended to protect the finish inside the drawers and make the drawers easier to clean.
• Grease the casters annually using high quality bearing grease.
•  Lubricate the slides semi-annually with general purpose grease or equivalent.
• Periodically clean the drawer fronts, drawer trim, and other surfaces with a mild detergent and water.
• Remove grease and oil with a standard nonflammable cleaning fluid.

3-YEAR HASSLE-FREE WARRANTY

For 3 years from the date of purchase, this product is warranted for the original purchaser to be free from defects in material and workmanship. This guarantee does not cover damage due to abuse, normal wear, improper maintenance, neglect, unauthorized repair/alteration, or expendable parts and accessories expected to become unusable after a reasonable period of use.
If you think your product meets the above guarantee criteria, please call our customer service department at 888-3KOBALT (888-356-2258), 8 a.m. – 8 p.m., EST, Monday –
Sunday. You could also contact us at partsplus@lowes.com, or return the item to the place of purchase with a copy of the original sales receipt. The distributor will, at its option, repair or replace the product. This warranty gives you specific legal rights, and you may also have other rights that vary from state to state.

REPLACEMENT PARTS LIST

For replacement parts, call our customer service department at 888-3KOBALT (888-356-2258), 8 a.m. – 8 p.m., EST, Monday – Sunday. You could also contact us at partsplus@lowes.com.

Printed in Cambodia
Questions, problems, missing parts? Before returning to your retailer, call our
customer service department at 888-3KOBALT (888-356-2258), 8 a.m – 8 p.m., EST,
Monday – Sunday. You could also contact us at partsplus@lowes.com.
SC22180

Documents / Resources

| KOBALT 19156 4-Drawer Steel Rolling Tool Cabinet [pdf] Instruction Manual
19156, 4-Drawer Steel Rolling Tool Cabinet, Rolling Tool Cabinet, 4-Drawer Tool Cabinet, Steel Cabinet, Cabinet
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>