IQxel Next Generation Connectivity Test System Specifications Manual

IQxelTM

Next Generation Connectivity Test System

General Technical Specifications

RF Analyzer

RF Analyzer — Signal Trigger

Baseband Analyzer

RF Generator

1 Automatic Level Control (ALC) enables the internal power detector to be used for power level feedback.

Baseband Generator

Port Isolation

Timebase

Wireless LAN (802.11a/b/g/n/p/ac) Measurement Specifications

Bluetooth® (1.0, 2.0, 2.1, 3.0) Measurement Specifications

1 IQxel supports testing sensitivity with Dirty Packets

Bluetooth (4.0, 4.1, 4.2) Measurement Specifications

1 NOC and EOC tests are the same except for the operating conditions which do not impact the test equipment requirements

2 External signal source required for these measurements (not LitePoint supplied)

3 IQxel provides the wanted signal only. No interfering signal is available

Bluetooth 5 Measurement Specifications

Bluetooth 5 introduced a couple of new test requirements:

Data Rate: New requirements for testing with 2 Mbps, 1 Mbps, 500 kbps, 125 kbps signal

Stable Modulation: Optional requirement for device to support smaller variation in the frequency deviation during modulation (modulation index between 0.495-0.505). This enhancement gives device stable and better range coverage and thus competitive advantage

ZigBee (802.15.4)

Z-Wave (ITU-T G.9959)

WiSUN MR-FSK (802.15.4g)

DECT (ETSI EN 300 176-1)

MIMO System Performance

The additional specifications in the table below apply to the complete IQxel MIMO system

Port Descriptions

Front Panel

Rear Panel

General I/O

Communication I/O

General and Environmental

Order Codes

IQxel Next Generation Connectivity Test System Specifications Manual – Optimized PDF
IQxel Next Generation Connectivity Test System Specifications Manual – Original PDF

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>