Lezyne PWR SUP LED Light User Manual

: June 8, 2024
: Lezyne

Table of Contents

Lezyne PWR SUP LED Light User Manual
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Lezyne PWR SUP LED Light User Manual

READ ENTIRE MANUAL BEFORE OPERATION to ensure proper use and care of your new Lezyne LED light. Traffic laws mandating lighting vary from country to country. Inform yourself about lighting laws in the country of use.

Lezyne PWR SUP LED

Warnings

DO NOT LOOK DIRECTLY INTO LIGHT BEAM or shine into eyes of another.

DO NOT SUBMERGE UNDER WATER. Lezyne LED lights are water resistant under normal conditions, but are not waterproof. If moisture gets inside light body, remove tailcap and air-out until completely dry.

DO NOT ATTEMPT TO REMOVE ELECTRONICS. Doing so will void warranty.

Use only genuine Lezyne branded LIR 18650 batteries. Never attempt to use two (2) LIR 123A batteries in place of one (1) LIR 18650 battery. See Charging for instructions on installing battery.

Lezyne USA, Inc. and Lezyne Co., Ltd. do not accept any liability for injuries or other damages resulting from the use of this product in any circumstances.

Mounting

Slide clamp over handlebar with bolt hole facing forward, place top mount on clamp, insert thumbscrew from bottom.
Tighten thumbscrew until snug; clamp should not rotate on handlebar. DO NOT OVERTIGHTEN. Max Torque: 5.0 Nm
Slide LED light into top plate from front. CONFIRM TAB ENGAGEMENT.

To remove LED light, depress release tab; pull light forward.

NOTE: When installing on carbon surfaces, verify tightening torque recommendation with the carbon parts manufacturer to prevent over tightening that can cause damage to the carbon material and/or under tightening that can cause lack of fixing strength.

Operation

ON/OFF: hold button two (2) sec.
Mode cycle: click button
Overdrive Race Mode: hold button five (5) sec.

OVERDRIVE RACE MODE: With the light OFF, hold button for five (5) seconds, until light flashes. The light is now in Overdrive Race Mode where only Overdrive and Economy outputs are selectable. The light will remain in Overdrive Race Mode even when switched OFF. Repeat the step above to return to the normal mode set.

THERMAL PROTECTION: If the operating temperature of the light is too high, the light automatically lowers the lumen output.

MAINTENANCE: For water resistance, ensure that tailcap, button, and USB protective cover are fully installed before every use. Keep tailcap threads clean and apply small amount of thick, multipurpose grease to tailcap threads if necessary.

Run Times and Modes

SUPER DRIVE:

SUPER DRIVE

POWER DRIVE:

POWER DRIVE

Battery Indicator

An LED, located in the button, displays current battery status while light is ON. When light is OFF, click button once to momentarily display battery status.

Battery Indicator

Charging

Before using your Lezyne LED Light for the first time, fully charge battery. To charge your light:

Open USB protective cover on bottom of light
Connect micro USB cable and light to powered USB port
Once charging, button will flash green; if USB port is capable, light will use High Efficiency (HE) charging and button will flash blue
If button does not flash when plugged in, selected USB port may not be powered—try another USB port.
Light will be charged after 4–6 hours (2–3 with HE charging) or when button illuminates solid green or blue.
Remove light from charger and reinstall USB protective cover—ensure USB protective cover is fully installed for water resistance

Remove light from charger

BATTERY REPLACEMENT: Unscrew tailcap, gently pull battery out—spring should automatically move out of the way; always ensure battery is installed in correct orientation and tailcap is fully installed for water resistance.