Rohnson M1 Cordless Vacuum Cleaner Instruction Manual

Rohnson M1 Cordless Vacuum Cleaner

Product List

Two different ways of charging, either through the hand held vacuum cleaner or separately

Installation of battery, electric floor brush, metal tube and handheld vacuum cleaner

Accessories attachment

Cleaning of dust container

Cleaning of filters

Cleaning the main power brush and rollers

SAFETY INSTRUCTIONS

The vacuum cleaner is specially used for household purpose, and please do not use it for commercial or other purposes.

1. Please don’t use the vacuum cleaner to suck detergent, kerosene, glass waste, needles, cigarette ash, moisturized dust, sewage, matches and similar articles.
2.  Please do not use the vacuum cleaner to suck cement, gypsum powder, wall power and similar small particles, or toy, paper filler and other larger objects, which can cause vacuum cleaner clogging, motor burnout and another fault.
3. Please do not use the vacuum cleaner near fire source and other high temperature places.
4. When the vacuum cleaner is used, please pay attention to install HEPA and rolling brush properly before operating the unit.
5.  When the vacuum cleaner is used, please note that the suction inlet cannot be clogged and rolling brush cannot be blocked, otherwise motor failure may be caused.
6.  Please do not dump or splash water or other liquid into the machine, to avoid short-circuit and burn-out of machine.
7. When cleaning the vacuum cleaner HEPA, please remove and wash it with water; when you need to use HEPA, please install the dried HEPA into the vacuum cleaner. Do not use the wet HEPA, otherwise it may burn out the machine due to the short-circuit.
8. Please use dry cloth for cleaning vacuum cleaner, do not use gasoline, banana oil etc. otherwise shell cracking or fading will be caused. Please do not use and store the machine in extremely adverse conditions, such as extreme temperature. Use the vacuum cleaner in room temperature of 5 C- 40 C. Please store it in a cool and dry place. Sunlight exposure for long time should be prohibited.
9. Make sure that the mains voltage matches the voltage stated on the rating label of the appliance and that the outlet is grounded.
10.  Do not use the device if it has been dropped or if there are any visible signs of damage.
11. Do not try to repair the appliance by yourself. Contact our official technical support service.
12. Do not use any accessory that has not been recommended by the manufacturer, as they might cause injuries or damage.
13. Turn off and unplug the appliance from the mains supply when it is not going to be used for a long period of time, before cleaning or repairing, before attaching components and before removing the battery.
14. Never modify the charger in any way.
15.  Do not use any battery that has not been provided with the original product.
16. The appliance is not intended to be used by children under the age of 12. It can be used by children over the age of 12, as long as they are given continuous supervision.
17.  This appliance is not intended to be used by persons with reduced physical, sesory or mental capabilities or lack of experience or knowledge unless they have been given supervision or instruction concerning the use of the appliance in a safe way by a person responsible for their safety and understand the hazards involved.
18. Supervise young children to make sure that they do not play with the appliance. Close supervi­ sion is necessary when the appliance is being used by or near children.

BATTERY INSTRUCTIONS

• This appliance includes Li-ion batteries, do not incinerate or expose them to high temperature, as they may explode.
• Leaks from the battery or battery cells can occur under extreme conditions. Do not touch any liquid that leaks from the battery. If the liquid gets into contact with skin, wash immediately with soap and water. If the liquid gets into the eyes, flush them immediately with clean water for a minimum of 10 minutes and seek medical attention. Wear gloves to handle the battery and dispose of immediately in accordance with local regulations.
• Avoid contact between the battery and small metallic objects such as paper clips, coins, keys, nails or screws.
• Before a new battery is used or the battery is used for the first time after long-term storage, fully charge the battery. When the device is stored and not used for long periods of time, ensure that the battery pack is fully charged and ensure that the battery is charged and discharged at least once every three months.

PRODUCT COMPONENTS (image 1)

1. Floor power brush
2. Floor power brush release button
3. Conductive metal tube
4. Accessory holder
5.  Wall-mounted storage base
6. Extension metal tube release button
7. Screws
8. Battery capacity indicator
9. Speed control button
10. ON/Off switch button
11. Battery release button
12. Dust container release button
13. Dust cover release button
14. Battery
15. Charger
16. Sofa nozzle
17. Narrow crevice tool
18. Mini power brush
19. Bristle roller brush for carpets
20. Soft roller brush for floors

Installation of battery pack and charging (Step 1)

You can use a hand to hold the hand-held vacuum cleaner firmly, the other hand to hold the battery pack. Insert the battery in the slot located in the body. Once it is inserted, move it slowly to ensure it is properly assembled in place. At this moment, it indicates that the battery pack is assembled. When the vacuum cleaner power is insufficient, please promptly charge the vacuum cleaner. The device can be charged in 2 different ways. It can be charged directly through the hand held vacuum cleaner (the three lights on the back of the body will indicate the state of the battery) or the battery can be removed and charged separately. Please remember to charge the battery after each cleaning session or when the battery is low.
Charge battery separately:Plug the cable into the power inlet located on the top of the battery. When charging, the energy indicator light will be illuminated RED. Once fully charged this indicator light will change to BLUE. Once fully charged, turn off the charger plug from the power socket. Charge battery on the unit: When no power, three lights give a flickering light. While charging, the light will become from one light to two lights, that means the battery is 50% charged. If the light illuminates 3 lights, that means 100% power.
The charging time is about 4-Shours.

NOTE:

1. In the event of a maintenance issue with the product such as a jammed brush roll, all three BLUE indicator lights will flash on and off until the issue is resolved, in this case turn the cleaner off until the issue is rectified.
2. Ensure that the air vent, floor brush and metal tube are free from blockages and dust. Should they suddenly become clogged, switch off the appliance immediately and clear the blockage before attempting to use the vacuum again.
3. Remove any sharp or large objects from the path of the vacuum before use as these may irrepa­rably damage the appliance.

Installation of electric floor brush, metal tube and handheld vacuum cleaner (Step 2)
NOTE: Before assembling the appliance fix the included wall-mounted storage base. Ensure it is placed high enough for the vacuum to be securely mounted.

1. Install the battery into the housing by sliding it into the appropriate slot. It will “click” into place.
2.  Insert the connector of the floor power brush into the base of the metal tube by clicking it into place.
3. Attach the floor power brush and metal tube to the main body by slotting it into place via the air duct connector.
4. If using the floor power brush without the tube, simply attach it to the main body via the air duct connector. It will “click” when secure.
5. The device includes two different rollers that allow cleaning different types of surfaces, the soft roller which is suitable for all types of floors (especially for wooden floors) and the bristle roller which is suitable for carpets. Both of them are interchangeable and are used with the floor power brush for the upright vacuum cleaner.

Attachment of accessories (Step 3)

1. Attach the metal tube to the main body by slotting it into place via the duct connector.
2.  Attach the narrow crevice tool to the base of the metal tube via the connector. It will “click” into place.
3.  If using accessories without the tube, simply attach them to the main body via the air duct connector. It will “click” when secure.
4. Attach the sofa nozzle and mini power brush to the metal tube or the main body, same as the narrow crevice tool.

Use sofa nozzle to vacuum fabric furnishings such as sofas, armchairs and curtains.
Use narrow crevice tool to vacuum narrow spaces such as corners and hard to reach areas. Use mini power brush to vacuum sofas, mattresses, stairs and in general for smaller surfaces.

Operation method

CAUTION: The vacuum must be fully charged before using for the first time.

1. Remove the vacuum cleaner from the wall mounted base. If using as a hand held unit, disassemble the metal tube and attach the desired accessory.
2. Use the Power ON/OFF button to turn on the appliance.
3.  For a stronger suction, press the speed control button to select maximum suction. You can switch to ECO and max (turbo) speed by pressing the speed control button. The power level can be adjusted at any moment by pressing this button.
4. To turn off the vacuum, press the Power ON/OFF button again.

Cleaning and maintenance

1. Do not use abrasive scouring pads, powders or cleaners to clean the device.
2. Use a soft, dampened and clean cloth to clean the products’ outer surface.
3. Do not let water enter into the vacuum cleaner.
4. Keep the appliance in a cool, dry place and out of reach from children.
5. Do not immerse the device in water and do not clean any of its parts in the dishwasher.

Cleaning of the dust bin (Step 4)

1. Press the dust cup release button and rotate the cup clockwise.
2.  Take off the dust cup from the main body.
3. Over a waste bin, press the dust release button to open the bottom cover and throw away any dust, dirt and debris. Wipe clean only, do not submerge in water.

NOTE: It is recommended to clean the dust bin after each use. You should remove plastic filter firstly.

Cleaning of filters (Step 5)

If the filters are so dusty that suction does not return to 100%, it is suggested to be cleaned or washed. if necessary, they can also be replaced. It is suggested to clean the filters regularly (at least once a month) to ensure maximum efficiency. They can be cleaned with cold or warm water. It is suggested to replace the HEPA filter twice a year. Both cleaning and replacement depends on use. ATTENTION: Dry them thoroughly before installing them back in the unit. Allowed them to dry 24 hours by airing not near the fire or some high temperature objects before refitting into the vacuum.

1. Remove the dust container from the main body.
2.  Twist the steel-filter clockwise and take off the filter
3. Remove the HEPA filter from steel-filter
4. Rinse thoroughly under clean fresh water. Do not use soap or other cleaning agents.
5. Allow filter to dry naturally before placing back into the vacuum. Do not place on radiators or  use additional appliances, such as a hair dryer, to dry the filter. Doing so may cause the filter to warp or for other irreparable damage to occur.

Cleaning of floor power brush and rollers (Step 6)

After the floor power brush has been used for a long time, its brush may wind around the hairs and the long flosses. It is important to clean the floor power brush regularly to avoid hair and other foreign objects from tangling, prevent blockages and ensure the vacuum cleaner can work more efficiently.

1. Pull downwards the brush roll securing clip from the brush and remove the safety brush roller clip.
2. Remove the roller from the brush housing.
3. Carefully clean and remove any hairs and fibers from the roller. Wash them under running water, do not use harsh cleaning agents.
4. If rollers become damp during cleaning, allow to dry naturally before replacing them into the housing.
5. Pull downwards the brush roll securing clip and hold. Place the safety brush roller clip into initial position and release the securing clip.

Troubleshooting

The following points should be firstly checked before you address to the service repair depart­ment:

Note: For any further doubt, please contact the nearest authorized service department of our company.

TECHNICAL SPECIFICATIONS

• MODEL: Rohnson mamba one M1
• Battery: Li-Ion 29,6V 2200mAh, 8 battery cells Watt: 31 SW max
• Digital motor (BLOC motor)

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE 2002/96/EC.
At the end of its working life, the product must not be disposed of as urban waste. It must be taken to a special local authority differentiated waste collection center or to a dealer providing this service. Disposing of a household appliance separately avoids possible negative consequences for the environment and health, deriving form inappropriate disposal and enables the constituent materials to be recovered to obtain significant savings in energy and resources. As a reminder of the need to dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>