FEIT Electric PLUG/WIFI/WP(N) Smart WiFi Dual Outdoor Plug Installation Guide
- June 3, 2024
- Feit Electric
Table of Contents
FEIT Electric PLUG/WIFI/WP(N) Smart WiFi Dual Outdoor Plug
IMPORTANT SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be followed.
THIS OUTDOOR SMART PLUG IS A “GROUNDED” DEVICE The male plug contains a ground
pin and is only intended for use with a three-pronged grounded outlet.
DO NOT ATTACH A DEVICE THAT EXCEEDS THE UNIT RATINGS
TROUBLESHOOTING TIPS
If you are having difficulty connecting:
- Make sure the Wi-Fi network is a 2.4 GHz network and Bluetooth. Outdoor Smart Plug will not connect to a 5 GHz network Test your Wi-Fi and Bluetooth network with other devices such as your phone to make sure it is operating properly. The Wi-Fi and BlueTooth connection may not have good coverage dung set up. Try moving the Outdoor Smart Plug closer to your Wi-Fi router and Bluetooth.
- Your Wi-Fi and BlueTooth network password is case-sensitive, make sure you are entering it correctly.
Devices plugged into your Outdoor Smart Plug must be ON in order to be
controlled via the mobile app. Please also check the App User Guide for more
information
Supplier’s Declaration of Conformity: 47 CFR § 2.1077 Compliance
Information Responsible Party: Feit Electric Company 4901 Gregg Road, Pico
Rivera, CA 90660, USA 562-463-2852
Unique Identifier: PLUGN./IFIN./P(N)
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including ince that may cause deviation. Note: This equipment has been tested
and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not
installed and used indance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures: Reorient
or relocate the receiving antenna. Increase the separation between the
equipment and the receiver. Connect the equipment to an outlet on a circuit
different from that to which the receiver is connected. Consult the dealer or
an experienced radio/tv technician for help. Any changes or modifications not
expressly approved by the manufacturer could void the user’s authority to
operate the equipment. FCC Radiation Exposure Statement: This equipment
complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum
distance of 20cm between the radiator& your body.
LIMITED WARRANTY. This product is warrantied to be free from defects in
workmanship and materials for up to 1 year from the date of purchase. If the
product fails within the warranty period, please visit it. comp for
instructions on replacement/refund or call 866.326.BULB. REPLACEMENT OR REFUND
IS YOUR SOLE REMEDY. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY
IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY.
LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES IS HEREBY EXPRESSLY
EXCLUDED. Some states and provinces do not allow the exclusion of incidental
or consequential damages, so the above limitation or exclusion may not apply
to you. This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state or province to province.
- Works with the Feit Electric app
- ELECTRICAL RATINGS: 125VAC, 60Hz
- 15A, Max. Resistive: 1875W SA, Max. Tungsten: 1000W
- FEIT ELECTRIC COMPANY Pico Rivera, CA, USA www.feit.com
Getting Started
-
Download the Feit Electric app on your smart device
-
Plug in your Outdoor Smart Plug
Plug the Smart Plug into an outdoor-rated GFCI receptacle with an appropriate outdoor cover.
WARNING: These products may represent possible shock or fire hazards if improperly installed or attached in any way. Products should be installed in accordance with the owner’s manual, current electrical codes, and/or the current National Electric Code (NEC). The indicator light must be rapidly blinking to connect. f not already blinking. press and hold the power button for five seconds. -
Launch and use the Feit Electric app to complete the set up
Tap Add Device or the + sign, then select Outdoor Plug and confirm. You will be prompted to enter your Wi-Fi network and password. Or you can be prompted to
enter your Bluetooth.
Be sure to connect to a 2.4 GHz Wi-Fi network that covers your installation location. Or be sure to connect to a 2.4GHz BLE. -
Plug your device into the Outdoor Smart Plug
Ensure your device is switched to the ON position and plug it into the Outdoor Smart Plug. -
FINISHING INSTALLATION
Once you’re up and running, secure the Outdoor Smart Plug to the wall by inserting a screw (not included) through the strain relief tab. Make sure to tightly cap the Outdoor Smart Plugs when not in use.
(Optional) Connect to Google Assistant or Alexa using the in-App guide
Need Help?
- Thank you for your purchase.
- Questions, comments, or feedback?
- We’d love to hear from you.
- Visitfeit.com/help for support or connect with us:
- Thank you for your purchase. Quest ons, comments or feedback? We’d love to hear from you Visitfeit.com/help for support.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>