stanton STX Portable Table Leaked User Guide

: June 4, 2024
: stanton

Table of Contents

GETTING STARTED
Connection Diagram
Features
SUPPORT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

stanton STX Portable Table Leaked User Guide

GETTING STARTED

Package Contents: STX. USB-C Cable. Stickers, Quickstart Guide, Safety & Manual.

Important: Make sure to insert the batteries (18650 3.6v) in the proper direction in the battery compartment on the bottom panel. If not, the fuse may blow, requiring the bottom cover to be removed to access the fuse. Replace batteries only with the equivalent type.

Connection Diagram

A. Stereo Input: Connect this input to an additional audio device (computer, smartphone, tablet, etc.).
B. Headphone Output: Connect stereo headphones to either of these audio outputs.
C. Line Out (RCA): Connect these line-level outputs to the inputs of an external audio device (mixer, PA system, powered speaker, etc.).
D. USB-C Port: Use the included USB-C cable to connect the unit to a power adapter (sold separately) connected to a power outlet and let the batteries charge for up to 4 hours.

Note: When the unit is plugged in to power, there will be no charging LED or indicator.

Features

Tonearm: This is a ready-to-use pre-balanced tonearm and cartridge. The cartridge is user-replaceable. To play a record, gently move the tonearm over your record on the platter and lower the tonearm onto the record. Press the Start/Stop button to start or stop the platter spinning.
RPM Selector: Use this switch to select the speed of the platter: 33 1/3, 45, or 78 RPM.
Pitch Slider: Move to adjust the tempo and pitch of the platter’s audio playback.
Tone: Turn this knob to adjust the low and high frequency audio levels of the record playing.
Audio: Turn this knob to adjust the volume of the speaker, headphone outputs, and line outputs.
Start/Stop Button: Press to start and stop the platter. The blue LED will be dim when the platter is stopped and bright when the platter is spinning.
Rotatable Fader: Move this crossfader to mute or unmute the volume of the speaker, headphones outputs, and line outputs.
Fader Selector Switch: Adjust this switch to select which of the 2 fader inserts is active.
Fader Reverse Switch: When engaged, this switch will reverse the fader cut to the opposite side.
Crossfader Cut-in Adjust: Turn this knob to set the cut-in of the crossfaders.
Crossfader Curve Adjust: Turn this knob to set the fader curve.
Speaker: This speaker outputs the audio signal from the record, Bluetooth source, and stereo input.
USB-A Port: Insert a USB flash drive here for USB audio recording.
USB Record: Press this button to start and stop recording to a connected USB audio thumb drive.
Bluetooth: Press and hold this button for 3 seconds to pair to a Bluetooth device. The LED will illuminate blue when paired.