Sudio Tolv True Wireless Earphones Owner’s Manual
- June 5, 2024
- Sudio
Table of Contents
Owner’s Manual
Studio Tolv, True Wireless Earphones
PRECAUTIONS AND USAGE
Do not use the product in other ways than described. Handle with care at all times and protect from damage. Do not expose the earphones to heat, magnetism, cold, damp environments, or abnormal wear and tear e.g. by bending or pulling them. Avoid dropping, strong impact, or winding the cable tightly. Clean with a slightly damp fabric. The WEEE-symbol means that the product should not be mixed with normal household waste, please return to facilities for Waste Electrical and electronic equipment.
WARNING
Never listen to music at an uncomfortably high volume, this may permanently damage your hearing. Never use the earphones in traffic or in other places where your hearing is needed to perceived dangers. Always store small accessories out of small children’s range. Always lower the volume before you connect.
SPECIFICATIONS
Bluetooth Version: V5.0, class II
Bluetooth Profile: HFPv1.7 HSPv1.2 A2DPv1.3
AVRCPv1.6, SPP1.2
Bluetooth Range: 15M
Music Time: 7 hours
Talking Time: 7 hours
Charging Time: 1.5H
Charging Type: 3.7V, 50mAh (earphone) rechargeable lithium-polymer battery
Operating Temperature: -10 – 55°C
Charging case: 500mAh (case) rechargeable lithium-polymer battery
POWER ON / PAIRING MODE
Lift both earphones from the charging case and they will be in pairing mode. Select “Audio Tolv” in the Bluetooth list on your device.
MUSIC CONTROLS
Play/Pause = Press button once
Next song = Press the R button two times
The previous song = Press the L button two times
PHONE CONTROLS
Answer call = Press R once
Reject call = Press and hold R for two seconds
TROUBLESHOOTING
If the earphones are behaving unexpectedly or you’re having difficulty pairing, we recommend a reset.
- Turn off both earphones by pressing and holding both buttons for six seconds. Start the earphones again by pressing and holding both sides for thirteen seconds, until the lights stop blinking.
- Put the earphones back in the case and wait for 10 seconds. They are now reset.
FCC RADIATION EXPOSURE STATEMENT:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Product name: Studio Wireless. Swedish design, made in China. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate. the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
ADMINISTRATIVE REGULATIONS ON LOW POWER RADIO WAVES RADIATED DEVICES WARNING
Without permission granted by the NCC, any company, enterprise, or user is not
allowed to change frequency, enhance transmitting power or alter original
characteristics as well
as performance to approved low-power radio-frequency devices. The low power
radio-frequency devices shall not influence aircraft security and interfere
with legal communications; If found, the user shall cease operating
immediately until no interference is achieved. The said legal communications
mean radio communications are operated in compliance with the
Telecommunications Act. The low-power radio-frequency devices must be
susceptible to interference from legal communications or ISM radio wave
radiated devices.
ADDRESS
Sudio AB
Grev Turegatan 35
SE-11438 Stockholm
Sweden
For more information, visit: www.sudio.com/faq
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>