itAM electronic MiniMag-1180 CB6025 CD Magnetic Mount Antenna Instructions

itAM electronic MiniMag-1180 CB6025 CD Magnetic Mount Antenna

TEAM Electronic GmbH Bolongarostrasse 88 D-65929 Frankfurt am Main, Germany
Tel. (++49) 069 -3009500
Fax (++49) 069 – 31 43 82
e-Mail team-electronic@t-online.de

ASSEMBLY & INSTALLATION

The MiniMag-1180 is easily and quickly to install. The antenna contains the following parts:

• Antenna whip (29 cm) with protective cap on top, bottom coil and spring
• magnetic base with attached cable (3.8 m) and PL jack,
• Allen key for fastening of the antenna whip.

Instructions

1. Screw the antenna whip onto the thread of the magnetic base.

2. The antenna has to be attached to a plain, even and thor­oughly cleaned metal surface (vehicle’s roof or trunk) with the magnetic base. For optimal adjustment, it is suggested to place the antenna in the middle of the selected surface.

3. Do n..oJ remove the protective foil under the magnetic base. The bottom of the magnetic base is covered with a rubber cover to protect the finish of your car.·

4. Run the antenna cable through the window or the door of the vehicle. Do not bend the cable excessively and do not extend or shorten the cable lo avoid difficulties with the adaptation of
   the antenna and radio.

5. Connect the PL jack at the end of the cable with the CB radio.

6. By default, the antenna is already adjusted for the 27 MHz free­
   quency range. The differences in vehicle types and possible pla­cement of the antenna have an effect on the efficiency of the antenna. Fine-tuning could enhance the performance of the system.

In any Gase, a check of the swr ratio is recommended. To perform this test, use an swr-meter, e.g. TEAM SWR-1180 series.
If an adaptation is necessary, open the alien screw at the top of the antenna coil and bring the antenna whip further in or out until the best SWR ratio is achieved.

Technical data

• Frequent: Range / Freq. Range SWR 26.8 • 27.6 MHz
• SWR **** 1,2 : 1
• Transmission power/power 10 W konstant/continuous  30 W Spitze/short time
• Bandwidth (SWR 2:1) 620 kHz
• Impedance 50 Ohm
• Cable Length 3.8 m
• Polarity vertikal/vertical
• Diameter 68mm
• connector UHF (PL-259)
• material slainless steel

Specifications subject to change without notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>