LAOTIE Electric Scoter User Manual
- June 7, 2024
- LAOTIE
Table of Contents
User Manual
ES18 Elecric Scooter
Product Introduction
Product Overview
Main Part Introduction
- Front light button
- turn signal button
- Horn Button
- Volt lock with key
- Smart display (with USB port)
- Speed limit button
- Single/Dual enging button
Folding Instructions
- Press the button on the rod to lower position
- Rotate the outer ring of the handle
- Fold the handle
- Pull out he red rod
- Press sliver rod to lower the scooter
- Done
Charge Your Scooter
Safety Instructions
This manual has been created to help you understand the safe use and maintenance of LAOTIE ES18 electric scooter.
- Persons without excellent vision, balance, coordination, reflex, muscle and bone strength and good decision-making capabilities should not use this product.
- The user of this product assumes ALL risks associated with its use. To minimize these RISKS, the user must wear safety helmet, goggles, gloves, elbow and kneepads and appropriate footwear.
- This manual contains important safety information. It is your responsibility to review this information and make sure that all riders understand all warnings, cautions, instructions and safety. We’re not liable for incidental damages or consequential damages due directly or indirectly to the use of this product.
- Riding the electric scooter can be a hazardous activity. Certain conditions may cause the equipment to fail without fault of the manufacturer. Like other electric products, the scooter can and is intended to move and it is therefore possible to lose control, fall off and/or get into dangerous situations that no amount of care, instruction or expertise can eliminate. If such things occur you can be seriously injured or die, even when using safety equipment and other precautions. RIDE AT YOUR OWN RISK AND USE COMMON SENSE.
Always follow the local laws and regulations.
- Understand your local laws permitting the use of Electric scooters
- Never ride your scooter in conditions of poor visibility.
- Do not do stunts, wheelies or jumps. They will increase your chances of injury and damage your LAOTIE ES18.
- Never carry passengers
Display Manual
ON/OFF:
Long press “Power” Button for 3 seconds to start or shut down the scooter.
Auto OFF: After five minutes of non-using any function, the scooter will be
automatically power off.
Display content switch:
In power on condition, short press “Power” Button to switch TRIP/ODONOL on the
LCD display.
Note : TRIP is Single mileage, ODO is cumulative mileage, VOL is battery
voltage.
Speed Mode Switch: In power on condition, short press “Mode” Button to
switch speed mode.
Parameters Settings:
Enter/Exit Settings Interface : Long press the “Mode” &”Power Button together
for 3 second.
P00-P09 Switch: Short press “Mode” button to switch code number.
Value Adjustment: Short press “Mode” or “Power” Button to adjust.
| Code Number | Meaning | Detail |
|---|---|---|
| P00 | Wheel diameter setting | Programmed by the controller, not available. |
| P01 | Under-voltage setting | The standard Parameter should be 50.5 for the |
LAOTIE ES18 electric scooter. Not recommend to change.
P02| Number of pole pairs setting| Programmed by the controller, not
available.
P03| Speed signal selection setting| Programmed by the controller, not
available.
PO4| KM/ Mile selection setting| 0 is Km, and 1 is Mile.
P05| Non-zero and zero start selection| Programmed by the controller, not
available.
P06| Cruise and Non-cruise selection| 0 is Non-cruise, and 1 is Cruise
P07| Soft start and hard start selection| This P07 setting has been
programmed by the controller, not changeable.
P08| Speed limit adjustment| If we want to reduce the top speed, we can press
Power” or “Mode” button to Decrease or increase the percentage number (For
example, if we want 50% of the top speed. wecan reduce the percentage number
to be 50%)
P09| EBS brake strength adjustment| Programmed by the controller, not
available.
Specification
| Items | Specifications |
|---|---|
| Brand | LAOTIE |
| Model | ES18(P) |
| Motor | Dual 2800W (Peek power) Motors |
| Battery | ES18 (60V31.2Ah) / ES18P (60V33.6Ah) |
| lire | 11 inch Pneumatic Wide Tires |
| Controller | 45A Controller * 2 |
| Brake | Front and Rear Oil Brake & EABS |
| Max Speed | 85 km/h |
| Max Range | ES18 (100km) / ES18P (120km) |
| Climbing Angle | 50° |
| Max Load | 200KG |
| Gross Weight | 54KG |
| Body Size | 130x126x28cm |
| Folding Size | 127x51x28cm |
| Package Size | 137x36x57cm |
Maintenance
Cleaning and storage
If you see stains on the scooters body, wipe them off with a damp cloth. If
the stains won’t scrub off, put on some toothpaste, and brush them with a
toothbrush, then wipe them off with a damp cloth. If you see scratches on
plastic parts, use sandpaper or other abrasive materials to polish them.
Notes: do not clean the scooter with alcohol, gasoline, kerosene or other
corrosive and volatile chemical solvents to prevent dire damage. Do not wash
the scooter with a high-pressure water spray. During cleaning, make sure that
the scooter’s turned off, the charging cable is unplugged, and the rubber flap
is closed as water leakage may result in electric shock or other major
problems. When the scooter’s not in use, keep it indoors where it is dry and
cool. Do not put it outdoors for long time. Excessive sunlight, overheating
and overcooling accelerate tire aging and compromise the scooter and the
battery pack’s lifespan.
Battery maintenance
- Use original battery packs, use of other models or brands may bring about safety issues;
- Do not touch the contacts. Do not dismantle or puncture the casing. Keep the contacts away from metal objects to prevent short circuit which may result in battery damage or even injuries and deaths;
- Use original power adapter to avoid potential damage or fire;
- Mishandling of used batteries may do tremendous harm to the environment. To protect natural environment, please follow local regulations to properly dispose used batteries.
- After every use, fully charge the battery to prolong its lifespan.
Do not place the battery in an environment where the ambient temperature is higher than 50°C or lower than -20°C (e.g., do not leave the scooter or the battery pack in a car under direct sunlight for an extended time). Do not throw the battery pack into fire as it may lead to battery failure, battery overheating, and even another fire. If the scooter is expected to be left idle for more than 30 days, please fully charge the battery and place it in a dry and cool place. Keep in mind to recharge it every 60 days to protect the battery from potential damage which is beyond limited warranty.
Always charge before exhausting the battery to prolong the battery’s lifespan. The battery pack performs better at normal temperature, and poor when it is below 0°C. For instance, when it is below -20°C, the riding range is only half or less at normal state. When the temperature rises, the riding range restores.
Note : fully charged ES18 Electric Scooter will last for 120-180 days. The built-in intelligent chip will keep a log of its charging and discharging records. The damage caused by prolonged no charge is irreversible and is beyond limited warranty. Once the damage is done, the battery can not be recharged (non-professionals are forbidden to dismantle the battery pack, as it may cause electric shock, short circuit or even major safety accidents).
Contact Us
Technical support Team: Support@Laotie.zone
If you have any inquires please feel free to contact us, we will reply within
24 hours.
Official Store
Scan the code to discover the latest from LAOTIE
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>