LAOTIE SR10 Electric Scooter User Manual

: June 6, 2024
: LAOTIE

Table of Contents

Product Introduction
Installation Instructions
Folding Instructions
Charge Your Scooter
Safety Instructions
Remote Control Instructions
Display Manual
Parameters Settings
Specification
Maintenance
Contact Us
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

User Manual
SR10 Electric Scooter

Product Introduction

Product Overview

Main Part Introduction

Front light button
Horn button
LCD display (with USB port)
Accelerator
Speed limit button
Single / Dual engine button

Installation Instructions

Install the front pole, insert the fixed shaft and tighten the screw
Lower and lock the fastener
Install the handlebar and tighten the screws
Install the headlight
Tighten the screw
Done

Folding Instructions

Unlock the fastener
Lift the fastener
Fold the pole
Done

Charge Your Scooter

Open the rubber flap| Plug the power adapter into the charging port| When charging is completed, put back the rubber flap

Safety Instructions

This manual has been created to help you understand the safe use and maintenance of the LAOTIE SR10 electric scooter.

Persons without excellent vision, balance, coordination, reflex, muscle and bone strength, and good decision-making capabilities should not use this product.
The user of this product assumes ALL risks associated with its use.
To minimize these RISKS, the user must wear a safety helmet, goggles, gloves, elbow and kneepads, and appropriate footwear.
Riding the electric scooter can be a hazardous activity. Certain conditions may cause the equipment to fail without the fault of the manufacturer. Like other electric products, the scooter can and is intended to move and it is, therefore, possible to lose control, fall off and/or get into dangerous situations that no amount of care, instruction or expertise can eliminate. If such things occur you can be seriously injured or die, even when using safety equipment and other precautions. RIDE AT YOUR OWN RISK AND USE COMMON SENSE.
This manual contains important safety information. It is your responsibility to review this information and make sure that all riders understand all warnings, cautions, instructions and safety. We’re not liable for incidental damages or consequential damages due directly or indirectly to the use of this product.

Always follow the local laws and regulations.

Understand your local laws permitting the use of electric scooters.
Never ride your scooter in conditions of poor visibility.
Do not do stunts, wheelies or jumps. They will increase your chances of injury and damage your LAOTIE SR10.
Never carry passengers.

Remote Control Instructions

Function	Details

Lock Your Scooter

| Single press the Lock Button, when you hear the beep sound, the scooter will be on alert.
Unlock Your Scooter| Press the Unlock Button once and then the Flash Button twice, when you hear the beep sound twice, the scooter will be unlocked.
Find Your Scooter| Single press the Find Button, and the scooter will beep for 7 times (Press the Unlock Button to stop the beep).

Display Manual

ON/OFF:
Long press the “Power” button for 3 seconds to start or shut down the scooter.
Auto OFF: After five minutes of non-using any function, the scooter will be automatically powered off.
Display content switch:
In power-on condition, short press the “Power” Button to switch TRIP/ODO/VOL on the LCD display.
Note: TRIP is Single mileage, ODO is cumulative mileage, VOL is battery voltage.
Speed Mode Switch: In power-on condition, short press the “Mode” Button to switch speed mode.

Parameters Settings

Enter/Exit Settings Interface: Long press the Mode Button & Power Button together for 3 seconds.
P00-P09 Switch: Short press the Mode Button to switch code number.
Value Adjustment: Short press the Mode Button or Power Button to adjust.

Code Number	Meaning	Detail
P00	Wheel diameter setting	Programmed by the controller, not available.
P01	Under-voltage setting	The standard parameter should be 50.5 for the

LAOTIE SR10 electric scooter.Not recommend to change.
P02| Number of pole pairs setting| Programmed by the controller, not available.
P03| Speed signal selection setting| Programmed by the controller, not available.
P04| KM/ Mile selection setting| 0 is Km, and 1 is Mile.
P05| Non-zero and zero start selection| Programmed by the controller, not available.
P06| Cruise and Non-cruise selection| 0 is Non-cruise, and 1 is Cruise.
P07| Soft start and hard start selection| This P07 setting has been programmed by the controller, not changeable.
---|---|---

P08

| Speed limit adjustment|

If we want to reduce the top speed, we can press Power Button or Mode Button to decrease or increase the percentage number. (For example, if we want 50% of the top speed, we can reduce the percentage number to 50%)

P09| EBS brake strength adjustment| Programmed by the controller, not available.

Specification

Items	Specifications
Brand	LAOTIAN
Model	SR10
Motor	Dual 1800W (Peek Power) Motors
Battery	60V28.8Ah 21700 Li-ion Battery
---	---
Tire	10-Inch Wide Tires
Controller	25A Controller * 2
Brake	Front and Rear Zoom Oil Brake & EABS
Top Speed	70km/h
Max Range	100km
Climbing Angle	40°
Max Load	150KG
Net/Gross Weight	40KG
Body Size	12764.5127cm
Folding Size	12764.549cm
Package Size	131.52551cm

Maintenance

Cleaning and storage
If you see stains on the scooter’s body, wipe them off with a damp cloth. If the stains won’t scrub off, put on some toothpaste, and brush them with a toothbrush, then wipe them off with a damp cloth. If you see scratches on plastic parts, use sandpaper or other abrasive materials to polish them. Notes: do not clean the scooter with alcohol, asoline, kerosene or other corrosive and volatile chemical solvents to prevent dire damage. Do not wash the scooter with a high-pressure water spray. During cleaning, make sure that the scooter’s turned off, the charging cable is unplugged, and the rubber flap is closed as water leakage may result in electric shock or other major problems. When the scooter’s not in use, keep it indoors where it is dry and cool. Do not put it outdoors for a long time. Excessive sunlight, overheating and overcooling accelerate tire aging and compromise the scooter and the battery pack’s lifespan.

Battery maintenance

Use original battery packs, use of other models or brands may bring about safety issues;
Do not touch the contacts. Do not dismantle or puncture the casing. Keep the contacts away from metal objects to prevent short circuits which may result in battery damage or even injuries and deaths;
Use original power adapter to avoid potential damage or fire;
Mishandling of used batteries may do tremendous harm to the environment. To protect the natural environment, please follow local regulations to properly dispose used batteries.
After every use, fully charge the battery to prolong its lifespan. Do not place the battery in an environment where the ambient temperature is higher than 50°C or lower than -20°C (e.g., do not leave the scooter or the battery pack in a car under direct sunlight for an extended time). Do not throw the battery pack into fire as it may lead to battery failure, battery overheating, and even another fire. If the scooter is expected to be left idle for more than 30 days, please fully charge the battery and place it in a dry and cool place. Keep in mind to recharge it every 60 days to protect the battery from potential damage which is beyond a limited warranty.
Always charge before exhausting the battery to prolong the battery’s lifespan. The battery pack performs better at normal temperature, and poor when it is below 0°C. For instance, when it is below -20°C, the riding range is only half or less at normal state. When the temperature rises, the riding range restores. Note: Fully charged SR10 Electric Scooter will last for 120-180 days. The built-in intelligent chip will keep a log of its charging and discharging records. The damage caused by prolonged no charge is irreversible and is beyond a limited warranty. Once the damage is done, the battery can not be recharged (Non-professionals are forbidden to dismantle the battery pack, as it may cause electric shock, short circuit or even major safety accidents).