LAOTIE N10 36V10.4Ah Electric Scooter User Manual
- June 6, 2024
- LAOTIE
Table of Contents
LAOTIE N10 36V10.4Ah Electric Scooter User Manual
Pakage Contains
Assembly instructions
Step 1 Products unfolds and folds
When the rapid pressing device is open, the positioning shaft can move freely
and when the mouth is pulled up The vertical position is in a free folding
state, and the product starts to unfold normally when the mouth is pulled
down.
Note: Remember that the compaction device is closed when the product is deployed
Step 2 Installation of handlebars
As shown : mount the instrument assembly on the handle and screw it tight
Step 3 Connection of communication lines
As shown: Connect instrument communication lines
Step 4 Installation check
Examine the tire pressure is sufficient（general front 2.0 back 2.2. The factory to protect the tire pressure is not enough，examine that the brakes are available
Operating instructions
-
Product function as shown below
-
Function details
-
When pressing the power off brake, cut off the power supply, the rear disc brake holding brake function is effective
-
Press the bell, handle the bell.
-
In the state of electrification, turn the accelerator handle counterclockwise and the car starts. The bigger the angle, the faster.
Warmtip: Please speedup slowly when starting -
Display screen: Turn on, Display screen, function asshown below:
A: File position highlight refers to the file position at the time
B: When the instrument is dormant, the button displays red light, and the
screen activates the display.
C: Key function
- Click to change gear(loop)
- Press twice to light the headlights and taillights
- The car automatically enters hibernation after resting for 5 minutes
Use of remote locks
Technical Parameters
| Name | Parameters |
|---|---|
| Brand | LAOTIE |
| Model | N10 |
| Motor Power | 350W |
| Range | 30-40km |
| Battery Capacity | 10.4Ah |
| Voltage | 36V |
| Max Speed | 30km/h |
| Charging time | 3-5H |
| Brake | Rear Disc Brake and EABS |
| Unfold size | 1110X450X1125 |
| Max load | 120KG |
| N.W | 13.9KG |
Repair and maintenance
Maintenance determines the service life, you need to understand the following common sense
- Check the tire pressure before using , Standard pressure 280Kpa
- Fully charged without working, makre sure charge and discharge a power every 2 months
- fullfil the powder after riding
- Do not use high-pressure water gun cleaning, to avoid damage of the internal n electronic components。
Regular maintenance
- Check the screw
- Check the tire
- Check the brake
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>