Nature POWER 60 LED Solar Security Light User Manual

: June 7, 2024
: Nature POWER

Table of Contents

User Manual
- Nature POWER 60 LED Solar Security Light
GENERAL SAFETY RULES
Part list
Assembly
Operation
Maintenance
Troubleshooting
Replacing Batteries
LIMITED WARRANTY
- References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

User Manual

Nature POWER 60 LED Solar Security Light

WARNING: Read and understand all instructions, warnings, and cautions before using this product. Failure to follow the instructions, warnings, and cautions may result in serious personal injury and/or property damage.

SAVE THESE INSTRUCTIONS

GENERAL SAFETY RULES

Save the receipt and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it.

This product is designed for certain applications only. The distributor cannot be responsible for issues arising from modification. We strongly recommend this product not be modified and/or used for any application other than that for which it was designed. If you have any questions relative to a particular application, DO NOT use the product until you have first contacted the distributor to determine if it can or should be performed on the product.

For technical questions please call 1-‐800-‐588-‐0590.

CAUTION: Do not allow persons to operate or assemble this Solar Light until they have read this manual and have developed a thorough understanding of how the Solar Light works.

**WARNING:** The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions or situations that could occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

**WARNING**
This product can expose you to chemicals, including Di (2-ethylhexyl) phthalate (DEHP) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.p65warnings.ca.gov

Part list

Lamp
Solar Panel (5M Wire)
Expansion Screw
60 LEDs
Battery Housing
Motion Detector head
U-Shaped Mounting Plate
ON/OFF/AUTO Switch
Battery Housing Outlet
Solar Panel Mounting Bracket
LUX Adjusting Dial (Shown in Fig 7)
SENS Adjusting Dial (Shown in Fig 7)
Time Adjusting Dial (Shown in Fig 7)
NI-HM Battery (Not Shown)

Assembly

Solar Panel Wall or Deck Mounted

Secure bracket to solar panel with screw provided as shown in Fig 5.
Set bracket on surface and secure in place with larger screws provided as shown in Fig 6.
Adjust angle of solar panel to ensure it receives optimum sunlight.

Note: The Solar Panel is equipped with a 5 meter cord so both units can be installed up to 5 meters apart.

Operation

Located on the front of the light there is a switch with 3 positions. (8) Fig 4.
a. ‘Auto’ – When the switch is in the ‘Auto’ position the 60 LED Solar Security Light will turn on automatically at night once motion is detected
b. ‘On’ – When the switch is in the ‘On’ position the light will remain on and can be used as a regular light.
c. ‘Off’ – When the switch is in the ‘Off’ position the light will remain off and will not detect any movement.
Allow 60 LED Solar Security Light to charge for at least 3 days with the switch in the ‘Off’ position.

How to use Control Dials (See Fig 7)
The 60 LED Solar Security Light has 3 different control dials which allow you to adjust the settings.

Sensitivity to Light (Lux)
The lights duration once motion has been detected (Time)
Sensitivity to motion (Sens)

Lux

This is the level of darkness reached before the light turns on
If set to maximum level the light will turn on in most situations ranging from dusk to daylight.
If set to minimum the sensor will only trigger when it’s dark. This is the most ideal position for general evening and night operation.

Time

The Time adjusting dial will set the duration of time the light will stay illuminated for after motion has been detected.
The time can be adjusted from 8 seconds up to 2 minutes.
Rotating the dial clockwise will extend the time the lamp is illuminated.

Sens

This determines the range of the motion detectorMid Position – Normal Setting Maximum position – Maximizes sensors range (12 Meters [40ft]). (Fig 8 and 9)

FIG 8 How to use Control Dials

Maintenance

Ensuring the lamp is kept clean will optimise performance
Clean Solar cell with a damp towel, Do not apply excessive pressure.
Do not use any solvents or cleaning agents on the solar modules.

Troubleshooting

If 60 LED Solar Security Light does not illuminate when movement in front of the sensor is obvious please observe the following.

Ensure the solar panel is in a location where it will receive maximum sunlight during daytime hours.
Clean solar cells with a damp towel, Do not apply excessive pressure and avoid the use of any solvents or cleaning agents on the solar cells.
Ensure switch is set to ‘Auto’.Check batteries are installed correctly.
Allow Panel to charge in direct sunlight for 2 days to confirm the batteries are fully charged.
Replace Batteries.

Note: Rechargeable batteries may last up to 800 charges. For best performance replace batteries every 12 months.

Replacing Batteries

Batteries are located in the battery housing located at the front of the lamp (5) Fig 3.
Remove screws from front of the battery housing to access batteries.
Replace batteries with rechargeable batteries of the same type and rating.
Reassemble battery housing.

LIMITED WARRANTY

Nature Power warrants our products to the original purchaser that this product is free from defects in materials and workmanship for the period of one year from date of purchase. In the case of product defect, contact Nature Power customer service to receive troubleshooting. If defective part or unit should be returned, a Return Authorization Number must be issued by Nature Power and the defective part or unit should be returned to the authorized location at the purchasers’ expense. A dated proof of purchase is required to receive warranty service. Once received at authorized location and defect proves to be the result of defective material and workmanship, the defective part or unit will be replaced at warrantors’ option and returned to the original purchaser at warrantors’ expense. No refunds will be granted by the warrant or, in the event of buyer’s remorse please contact your point of purchase within and in adherence to their return policy. Refunds are granted at the retailers’ discretions.

Please contact Nature Power Products to acquire more information:
1-800-588-0590
info@naturepowerproducts.com
www.naturepowerproducts.com
Made in China