TOPGREENER TGSFS3 Combination Light Switch and 3 Speed Fan Control Instruction Manual

June 3, 2024
Topgreener

TOPGREENER TGSFS3 Combination Light Switch and 3 Speed Fan Control
LOGO

TOPGREENER TGSFS3 Combination Light Switch and 3 Speed Fan Control

TOPGREENER TGSFS3 Combination Light Switch and 3 Speed Fan Control
PRODUCT

SPECIFICATIONS

  • Voltage……………………………………………………………………………….120VAC, 60Hz
  • Fan…………………………………………………………………………………………………..2.5A
  • Incandescent/ Halogen / LED / CFL……………………………………………………720W
  • Switch…………………………………………………………………………………………………6A
  • Wire Gauge……………………………………………………………………….#18 ~ #12 AWG

WARNING
Turn the power off at the circuit breaker before installing this device.
Read and understand these instructions before installing. This device is intended for installation in accordance with the National Electric Code and local regulations. It is recommended that a qualified electrician performs this installation. Make sure to turn off the circuit breaker or fuse(s) and make sure power is off before wiring the device.
Use copper wire only. No Aluminum.
INPUT: Use wires with minimum rating of 75° C (167° F)

WIRING DIRECTIONS

  1. Remove the wall plate.
  2. Remove existing switch from wall box and prior to disconnecting wires, identify the wires and label as needed.
  3. Remove wires from existing switch.
  4. Follow the diagram below to connect the TGSFS3TOPGREENER TGSFS3 Combination Light Switch and 3 Speed Fan Control 01

OPERATING INSTRUCTIONS

  • Before using this switch to control your fan, be sure to first set the speed on the ceiling fan to high. Some fan models may have a pull string attached to its side or underside. Please check the fan manufacturer’s instructions on how to change fan speed.
  • The fan control is off when the slider is at the zero position. Then as you slide it up through positions 1-3, the fan speed increases from low to high.
  • The light switch at the bottom controls the connected light/load.

IMPORTANT NOTICE

This is a SINGLE-POLE SWITCH
You must have two load wires in the switch box and a HOT wire in order to use this switch. One load wire goes to the LIGHT and the other load wire goes to the FAN

WARRANTY

This device is warranted to be free of material and workmanship defects for 1 year from the date of purchase. Original receipt or proof of purchase from an authorized retailer must be presented upon warranty claim. ALL claims must be verified and approved by Top Greener, Inc. Warranties from other TOPGREENER products may vary. This warranty is nontransferable and does not cover normal wear and tear or any malfunction, failure, or defect resulting from misuse, abuse, neglect, alteration, modification, or improper installation. To the fullest extent permitted by the applicable state law, Top Greener, Inc. shall not be liable to the purchaser or end user customer of TOPGREENER products for direct, indirect, incidental, or consequential damages even if Top Greener, Inc. has been advised of the possibility of such damages. Top Greener, Inc’s total liability under this or any other warranty, express or implied, is limited to repair, replacement or refund. Repair, replacement or refund are the sole and exclusive remedies for breach of warranty or any other legal theory.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals