ANKER Soundcore Portable Bluetooth Speaker Owner’s Manual

: June 7, 2024
: Anker

Table of Contents

Safety Instructions
- Notice
Charge Your SoundCore
Turn on / off
Bluetooth Pairing
NFC Pairing
Connect via AUX
Controls
Specifications
Customer Service
Read User Manual Online (PDF format)
Download This Manual (PDF format)

ANKER Soundcore Portable Bluetooth Speaker Owner’s Manual

Safety Instructions

Avoid dropping.
Do not disassemble.
Do not submerge in water.
Avoid extreme temperatures.
Use original or certified cables.
Do not use any corrosive cleaner/oil to clean.
Do not use the device outdoors during thunderstorms.

Notice

This product complies with the radio interference requirements of the European Community.

This product is designed and manufactured with high quality materials and components, which can be recycled and reused.

This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.

FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

This device may not cause harmful interference, and
this device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio / TV technician for help.

RF Warning Statement
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Charge Your SoundCore

Flashing red	Low battery
Steady red	Charging
Steady white	Fully charged

To preserve battery lifespan, fully charge at least once every 45 days.

Turn on / off

| Press| ON| | Steady white
---|---|---|---|---
Press and hold for 1 second| OFF| Off

Bluetooth Pairing

| Pres| Enter pairing mode
---|---|---
Press and hold for 2 seconds| Un-pair connected device and re-enter pairing mode
| Flashing blue| Pairing mode
---|---|---
Steady blue| Connected to a device

When turned on, SoundCore will automatically connect to the last connected device if available. If not, SoundCore will enter pairing mode.

NFC Pairing

To break connection, tap again the NFC device onto SoundCore’s NFC detection area.

Connect via AUX

SoundLine AUX cable sold separately

To return to Bluetooth mode, remove the AUX cable from your SoundCore.

Controls

x 1| Press| Play / pause
x 2| 2 Double press| Skip forward

+ /-

| Press| Volume up / down

1S| Press and hold for 1 second| Activate Siri / other voice control software
x 1| Press| Answer / End call
x 1S| Press and hold for 1 second| Reject call
x 1| Press| Put current call on hold and answer incoming call
x 1| Press| Switch between held call and active call
1S| Press and hold for 1 second| Transfer a call between speaker and mobile phone
| Steady blue| On a call
| Flashing blue| Incoming call

Specifications

Specifications are subject to change without notice.

Input	5V 2A
Play time (varies by volume level and content)	Up to 24 hours
Audio output	6 W × 2
Impedance	4
Range	20 m / 66 ft
Size	168 x 47 x 56 mm / 6.6 x 1.9 x 2.2 in
Charging time	3 hours
Driver (full range)	1.5″ x 2
Frequency response	70 Hz – 20 KHz
Bluetooth version	V4.2
Waterproof rating	IPX 5
Weight	408 g / 14.4 oz