DANCING WINGS HOBBY Tiger Moth Wingspan RC Airplane 400mm Instruction Manual
- June 7, 2024
- Dancing Wings Hobby
Table of Contents
Tiger Moth(X10)
INSTRUCTION MANUAL
Pls take down the parts from the board by knife,and assemble them as per the procedures as below,we suggest you shape with 502 glue, and firm with white latex.
Material:
- Basswood
- Balsawood
- Paulownia
- Fiberglass and others
Tools Needed
Fusalage Installation
Landing Gear Installation
Wing Installation
Down Wing
Up Wing
Install the finished down the wing and up the wing on A3 and A4. Connect the middle part between the up wing and down the wing with A1. Lastly, adjust the 1.Fuselage Installation wing straightly before sticking the joints with A4 F-6 glue.
Stick W-7-1 on the W-7, and sand it according to the wing’s radian.
Propeller Installation
Pulling Wire Installation Show
Pull the wire according to the numbers in the picture,”1″ is the starting
point, “7” is the finishing point. Insert “1” and “7” pulling wire into the
reserved hole of bracket, tie a knot, and fasten. 
Here use a self-tapping screw to fix the buckle on the fuselage, assist
pulling wire.
CHOKING HAZARD-
Small parts.Not for children under 3 years.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>