DANCING WINGS HOBBY 1.8M 1:5 Savage Bobber Balsa Wood Scale Airplane Instruction Manual

1.8M 1:5 Savage Bobber Balsa Wood Scale Airplane
Instruction Manual

1.8M 1:5 Savage Bobber Balsa Wood Scale Airplane

Specification

Wingspan:1.88M（74″）
Fuselage Length:1.30M（51″）
Flying Weight:≈3.8kg

Suggested Equipment

Motor : EP：MC3520 880KV
GP：2C 17cc or 50-55 Class
Prop : 14*7inch
ESC：80A（4S）
Battery：4S 5000mAh+
Servo : 37g EP：6pcs GP：7pcs
Radio：6CH

Tools Needed

KIT

SCG33-Fuselage
SCG33-Wing
SCG33-Cowling

Assemble the Landing Gear

Assemble the Tail Wing and Tail Wheel

Install the Wing

When installing the flap, drill holes in the reserved screw holes, and then tap a small amount of CA glue. After curing, screw in the self-tapping screws to install the hinges, so that the flaps can swing freely.

Connecting rod collet installation method

Note: the left and right wings are installed in the same way. Follow the above steps to complete the installation of the other wing.

One end of the connecting rod collet clamps the rudder horn, and the other end is inserted into the EZ-connector on the rudder arm.
After adjusting to the proper position, lock the screws on the EZ-connector.

Install the Motor and Cowling

Display the stay wire and scale parts

Set and Adjust

Usually, the control throws set as below:

Some special models will have V-tails, flaps, leading edge wings, etc., which can be used as a reference for conventional flight angles. If you do not confirm and there is no experienced person to guide you, we recommend that you first test at a small angle to confirm that your settings are correct.

Control Directions Tests

More details about power system adjustment, please refer to below link: (You can scan QR Code directly.)

http://www.dwhobby.com/art/connection

References

• DancingWingsHobby AEOrc ELErc HOBBY, RC PLANE,Balsawood Airplane,EPP Foamy Plane,BRUSHLESS MOTOR ,EDF,BLADE,PROPELLER
• How to Connect

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>