V-TAC Concrete Lawn Lamp Installation Guide
- June 7, 2024
- V TAC
Table of Contents
WEE Number: 80133970
INSTALLATION INSTRUCTION
CONCRETE LAWN LAMP
IP65
RATING
TECHNICAL DATA :
| MODEL | VT-898 |
|---|---|
| WATTS | 12W |
| BEAM ANGLE | 24° |
| CRI | >80 |
| PF | >0.55 |
| MATERIAL | CONCRETE |
| INPUT POWER | AC: 220-240V |
| DIMENSION | 495x180x120mm |
INTRODUCTION & WARRANTY
Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any other queries, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at your best. The warranty is valid for 3 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours of Daily operation. Usage of product for 24 hours a day would void the warranty. This product is warranted for manufacturing defects only.
WARNING!
1. Please make sure to turn off the power before starting the installation.
2. The light source of this luminaire is not replaceable, when the light
source reaches its end of life the whole luminaire should be replaced.
3. Installation must be performed by a qualified electrician.
This marking indicates that
this product should not be disposed of with other household wastes.
Caution, risk of electric shock.
INSTALLATION DIAGRAM
Step 1: Switch off the power before starting the installation.
Step 2: Release the base plate by unscrewing the screws (Ref 5) from the
bottom of the fitting. Fix the power cable through the base plate (Ref 2) Wire
and connect the power cable using cable connector to the terminal block, then
drill the holes by using the base plate as a guide (Ref 1).
Step 3: Fix the base plate using the plugs and screws(included) (Ref 3).
Step 4: Mount the luminaire on the base plate using the screws. Make sure the
screws are properly fixed (Ref 4).
Step 5: Switch on the power to test the light.
In case of any query/issue with the product, please reach out to us at:
support@v-tac.eu
For More products range, inquiry please contact our distributor or nearest
dealers.
V-TAC EUROPE LTD. Bulgaria, Plovdiv 4000, bul.L.Karavelow 9B
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>