BreathableBaby Solid End Mesh Crib Liner Installation Manual
- June 7, 2024
- BreathableBaby
Table of Contents
Installation for Solid End Mesh Crib Liner
START HERE – Figure 1: Installing Panels
Step 1. Properly position each panel along INSIDE, BACK, and FRONT of the
crib with big hole mesh side facing inside the crib
1. Each panel covers slats at BACK and FRONT of the crib as shown above.
2. Make sure ties face UPWARDS and are OUTSIDE the crib.
Figure 2: Securing Ends of Panels
Step 2. Securing ends of panels (refer to Figure 1)
1. Wrap and secure fasteners around the last slats on the backside (a, b) and
front side (c, d) of the crib.
2. To prevent sagging, pull the liner tight at both ends for a snug fit.
Content: 100% Polyester
Easy Care: For best results, the machine washes a warm, gentle cycle.
Wash separately or with like colors. Only non-chlorine bleach when needed.
Tumble dry low.
SECURE ALL FABRIC FASTENERS BEFORE LAUNDERING TO AVOID SNAGGING.
WARNING
To reduce the risk of SUFFOCATION:
- Keep tight against side of crib. Do not use if liner is loose or sags down toward sleeping surface.
- Never put pillows or anything else in crib that could trap baby against this liner.
- Only use in a crib without broken parts or missing slats. This liner will not fix a broken crib or prevent baby from falling out. Never use in a toddler bed or bassinet.
To help prevent ENTANGLEMENT or STRANGULATION, position ties to outside of crib and secure tightly.
Remove this liner when baby can pull to a stand using crib side (starting about 6 months). Older babies can use liner to climb out of crib.
Questions? breathablebaby.com
877-827-4442
CustomerCare@breathablebaby.com
BreathableBaby, LLC
600 Highway 169 South, Suite 800
St. Louis Park, MN 55426
© 2020 BreathableBaby, LLC.
Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>