SONOFF SNZB-02 ZigBee Smart Home Temperature Humidity Finder User Guide
- June 3, 2024
- SonOFF
Table of Contents
SONOFF SNZB-02 ZigBee Smart Home Temperature Humidity Finder
The device can be operated intelligently via working with the SONOFF ZigBee Bridge to communicate with other devices.
NOTE
The device can work with other gateways supporting ZigBee 3.0 wireless
protocol. Detailed information is in accordance with the final product.
Operation instruction
- Download APP
- Pull out the battery insulation sheet
- Add sub-devices
NOTE
Connect the Bridge before adding the sub-device
Access eWeLink APP, select the Bridge that you want to connect, and tap “Add” to add a sub-device. Then long press reset button on the device for 5s until the LED indicator flashes three times, which means the device has entered the pairing mode, and be patient until pairing completes.
NOTE
If the addition failed, move the sub-device closer to the Bridge and try again.
Specifications
| Model | SNZB-02 |
|---|---|
| Battery model | CR2450(3V) |
| Wireless connection | ZigBee (IEEE 802.15.4) |
| Working temperature | -10℃~40℃ |
| Working humidity | 10-90%RH (non-condensing) |
| Material | PC |
| Dimension | 43x43x14mm |
Product Introduction
Features
SNZB-02 is a ZigBee low-energy temperature & humidity sensor that can be used to monitor the environment temperature and humidity in real time. Connect it with the Bridge and you can create a smart scene to trigger other devices.
- Low-energy
- Temperature and humidity monitoring
- Low battery notification
- Smart scene
SONOFF ZigBee Bridge supports connecting multiple sub-devices at the same time.
Power the Bridge on, access the Bridge page in the eWeLink APP, and tap “Add”. Then set the sub-device to be paired to the pairing mode, and be patient until the pairing completes.
Delete sub-devices
Long press the reset button on the sub-device for 5s until the LED indicator flashes three times. In this case, the sub-device is deleted from the Bridge successfully.
NOTE
Users can delete sub-devices directly from the sub-device page on APP.
Installation methods
- Placed on the desktop for use.
- Tear off the protective film of the 3M adhesives and stick the device on the desired area.
NOTE
- Do not install on a metal surface, otherwise, it will affect the wireless communication distance.
- The device’s weight is less than 1 kg. An installation height of less than 2 m is recommended.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>