ANKER PowerDrive Speed+2 Car Charger User Guide
- June 7, 2024
- Anker
Table of Contents
ANKER PowerDrive Speed+2 Car Charger User Guide
Using Your PowerDrive
- Plug it in
- Charge your phones and tablets
Note : For the fastest and safest charge, use an Anker R’ cable, your device’s original cable or a cable with recognized third-party certification (such as MFi).
Specifications
Input
| 12 V/24 V= 5A
---|---
PD Output
| 5 V=3 A/ 9 V= 3 A 15 V=2 A/20 V=1.5 A
PIQ 2.0 Output
| 5 V=3 A/ 9 V= 2 A/12 V=1.5 A
Size
| 63 X 35 X 35 mm 2.5 X 1.4 X 1.4 in
Weight
| 30g/1.1o
For FSQs and more information, please visit:
@Anker
@Anker Japan
@Anker Deutschland
@AnkerOfficial
@Anker_JP
@Anker
IMPORTANT SAFETY INSTRUCTION
(SAVE THESE INSTRUCTIONS )
- This manual contains important safety and operating instructions for this car charger Model A2229.
- Read all instructions and cautionary markings on this car charger before use.
- Do not expose this car charger to rain, moisture, or snow.
- Use of an attachment not recommended or sold by this car charger manufacturer may result in a risk of fire, electric shock, or injury to persons.
- To reduce risk of damage to cigarette lighter connector and cord, pull by cigarette lighter connector rather than cord when disconnecting this car charger.
- Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
- Do not operate this car charger with damaged cord or cigarette lighter connector – replace it immediately.
- Do not operate this car charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceperson.
- Do not disassemble this car charger; take it to a qualified serviceperson when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
- To reduce risk of electric shock, unplug this car charger before attempting any maintenance or cleaning. Turning off controls will not reduce this risk.
- To reduce the risk of fire or electric shock, do not interconnect output terminations.
- CAUTION
- For continued protection against risk of fire, replace only using fuses of the same type and rating: fuse rating 32Vdc, 7A.
IC Statement
This device complies with Industry Canada license – ICES-003. Operation is
subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of the device.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Warning : Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A2229 is in
compliance with Directive 2014/30/EU. The full text of the EU declaration of
conformity is available at the following internet address:
https://www.anker.com/products
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
Customer Service
18-month limited warranty
Life time technical Support
Support@anker.com
(US) +1 (800) 988 7973 Mon-Fri 9:00 – 17:00 (PT)
(UK) +44 (0)1604 936200 Mon-Fri 6:00 – 11:00 (GMT)
(DE) +49 (0) 69 9579 7960 Mon-Fri 6:00 – 11:00
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>