MINISO CH510 Minimalist Wireless Headset User Manual

MINISO CH510 Minimalist Wireless Headset

PRODUCT PARTS

1. Volume ../Previous
2. PlayfPause
3. Volume +-/Next
4. 3.5mm Audio Jack
5. LED Light
6. Mic
7. TYPE-C Charging Port

PRODUCT PARAMETERS

FUNCTIONS

CAUTIONS

1. Reasonable control of the volume and time of usage is required to avoid hearing damage
2. For your safety, do not use it in potentially hazardous condition
3. Do not listen to music, call up or answer the phone while driving to avoid danger caused by distraction
4. Keep it out of reach of children to avoid danger caused by improper use.
5. Do not throw to avoid damage caused by dropping.
6. Do not store or use it under -20″C or above 45″C to avoid shortening the lifespan of earphones and battery.
7. Do not modify, disassemble or repair the product.
8. irreplaceable battery. It should be disposed of according to local rules & regulations or be recycled by professional institute. Do not throw away or 106s into firs.
9. When not in use for s long lime, charge the earphones once every 3 months to extend its lifespan.
10. Avoid contact with water and other liquids to prevent them from penetrating Into the product.

TROUBLESHOOTING

1. Fall to pair the wire less earphones with your cellphone.
   Solution: Check if the earphones are in pairing mode, and whether the phone BT function is on. Check the list on your phone, remove the earphones from the list, follow the instructions of user manual to pair the earphones with your phone again.

2. Cannot turn an the wireless earphone
   Solution: Check the battery to see If It Is low.

3. Can the battery of the wireless earphone bud replaced?
   Answer: No. The lithium polymer buttery in the earphones is irreplaceable.

4. The wireless earphones got disconnected with the phone within 10 meters.
   Solution: BT is wireless so that it is very sensitive to objects between the earphones and the connected device. Check if there are any metal or other objects that may affect the connection within the effective distance.

5. Cannot hear audio playing when the earphones are connected to the computer or phone.
   Solution: Check whether the computer’s audio output is already connected to wireless device and whether the Bluetooth in the computer supports A2DP protocol. Make sure the volume is up on your phone or computer.

6. Can I operate the Apps of my phone through the earphones after connecting the wireless earphones to the phone?
   Answer: Some apps may not support being operated through the earphones due to their settings.

FCC Warning:

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference
2. this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital devic are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular pursuant to part 15 of the FCC Rules. These limits installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equiptent and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  The device has been evaluated to meet general RF exposure requirement.
  The device can be used in portable exposure condition without restriction.

ISED Warning::
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
   • This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
   • The device has been evaluated to meet general RF exposure requirement.
   • The device can be used in portable exposure condition without restriction.

WEB:www.miniso.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>