CANYON Smart Watch User Guide
- June 7, 2024
- CANYON
Table of Contents
CANYON CNS-SW51BB Smart Watch User Guide
DEVICE DESCRIPTION
Attention!
These watches do not have the Touch Screen technology, so all manipulations are performed using the A, B, C, D buttons or their combinations.
Switching on/off
Press and hold buttons B and C
FIGURE 1
DISPLAY MODES FUNCTIONS ON THE SCREEN:
Time setting
To enable automatic setting of the time, connect your watch to the phone via Canyon Fit.
To make manual settings, do as follows: Press button D and hold it till the device switches to the `time setting mode’: the time indicator begins to blink. By using buttons A and C to increase or decrease the numeric value, you can set the time. Use button D for switching between hours, minutes and the date display mode (24 or 12 hours) Store your settings by briefly clicking button B.
Date setting
To enable automatic setting of the date, connect your watch to the phone via Canyon Fit.
To make manual settings, do as follows: Briefly click button B to display the current date.
Press button D and hold it till the device switches to the `date setting mode’: the date indicator begins to blink. By using buttons A and C to increase or decrease the numeric value, you can set the date. Use button D for switching between the year, day and month.
Briefly click button B to save the current settings.
Alarm clock setting
As displayed in Figure 3, enter the `alarm clock screen’ by using button B. To set the alarm clock, press and hold button D. Use buttons A and C to activate and set the new alarm time. Use button D for switching between hours and minutes. Press button B to store changes.
After the alarm is activated, switch off the alarm clock by pressing any button.
Device use:
To switch on the backlight, short click button A.
To activate Bluetooth on the watch, press button A and hold it till a corresponding symbol appears on the screen.
Use button B for the navigating through the watch menu. The menu mode will change each time this button is pressed.
All the display modes and the principle of navigating through the menu are shown in Fig. 2.
FIGURE 2
The navigation between functions (or menu items) is performed by pressing the B button.
- Main screen
- Date in the mm.dd format
- Pedometer. This screen displays the number of steps made during the day. The steps are counted by means of a special integrated sensor, which is sensitive to arm movements.
- Calories. This screen displays burned calories. Measurements are calculated by a predefined mathematical model using the pedometer data.
- Distance. This screen displays the distance travelled. Values are calculated based on the pedometer readings using a pre-set mathematical model.
- Alarm clock. This screen displays the current alarm clock time To set the alarm clock, see the Alarm Clock Setting Section
- *Temperature.** This screen displays the air temperature.
- *Barometer/altimeter.** By default, this screen displays the atmospheric pressure (Pa); to switch to the altimeter, briefly press button C
- *UV radiation level .** This screen displays the current UV radiation level
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>