AQara Smart Wall Switch User Guide
- June 7, 2024
- Aqara
Table of Contents
AQara Smart Wall Switch
This product requires a compatible hub. Some features require a specific hub. For the detailed list, please visit: www.aqara.com/support
Warning
- A certain amount of electrical knowledge is required to install a smart wall switch. For your safety, we recommend that you ask a qualified electrician to help you install it;
- This product is for indoor use only; do not use it in humid environment;
- Do not install this product near a heat source;
- IMPORTANT!: This Smart Switch is rated for and intended to only be used with copper wire.
Before You Install
This product is only used to replace a single pole switch rather than a 3-way
switch.
Installation
Visit www.aqara.com/support for more information.
-
Turn off power at circuit breaker or fuse box and test that power is off before wiring. (Please switch the light several times to make sure that the power has been disconnected).
-
Remove the existing switch and identify the wires with wire labels.
-
Install the smart wall switch and connect wires as required.
-
Tuck the wires into the wall box leaving room for the smart switch. Using the screws provided, mount the smart switch to the wall box. Be careful not to crush any wires. (Note: avoid over tightening the screws.)
-
Install the wall plate, turn main power ON at the circuit breaker, and test the switch by pressing the button;
If it doesn’t work, please check: a. If the wiring is correct; b. If the power is restored.
If it works, add the switch to the app following the next steps;
Quick Setup
- Please add the Hub to the app according to the Hub Quick Start Guide.
- Please open the app, and then tap “+” in the top right corner to enter “Add Device (Accessory)” page. Select “Smart Wall Switch (No Neutral, Double Rocker)”, and add it according to instructions.
*If the connection fails, please move the hub closer to the switch, connect to power and try again.
Effective Range Test: Quick press the button on the device 3 times. If
the Hub makes voice prompts, it indicates that the device can communicate
effectively with the Hub.
Indicator Light Description
| Indicator Light Status | Status Description |
|---|---|
| Blue light blinks quickly | Zigbee network is connecting |
| Blue light keeps on | Zigbee network works properly |
| Red light blinks quickly | High temperature alarm |
| Red light blinks slowly | Zigbee network is not connected |
Specification
Model: WS-USC02
Dimensions: 120 x 74 x 36.5 mm (4.72 x 2.91 x 1.44 in)
Wireless Protocol: Zigbee 3.0
Input: 120 V AC 60 Hz
Min Load: 3 W/way (Incandescent), 5 W/way (CFL/LED), typical load Max Load:
600 W/way (Incandescent), 200 W/way (CFL/LED), 1/4 HP Operating Temperature: 0
– 40° C（32 – 104° F）
Operating Humidity: 0 – 95% RH, non-condensing
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>