DYNOJET 91012001 BMW Velocity Stacks Installation Guide
- June 3, 2024
- Dynojet
Table of Contents
DYNOJET 91012001 BMW Velocity Stacks Installation Guide
PARTS LIST
- 2 VELOCITY STACKS
- 2 HOSE CLAMPS
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.
THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.
INSTALLING THE VELOCITY STACKS
-
Remove the seat.
-
Remove the bodywork around the fuel tank / airbox area.
-
Remove the airbox lid to access the air filter.
-
Remove the air filter
-
Remove the clamps from the intake boot to the airbox on each side of the motorcycle.
These clamps can be reused if desired by using special pliers
-
From the inside of the airbox grab the stock velocity stack and pull it out of the rubber boot.
-
Install the Dynojet velocity stacks in place of the stock part.
Make sure to align the tab on the velocity stack with the mark on the airbox. Ensure the velocity stack is fully seated within the rubber boot.
-
Reinstall the stock clamps or use the supplied clamps in the kit.
-
Reinstall the air filter and bodywork.
PUSH THE LIMIT
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081
–800-992-4993 –
DYNOJET.COM
© 2010-2020 DYNOJET RESEARCH ALL RIGHTS RESERVED
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>