anko BOUNCE ACTIVITY CENTRE Instruction Manual
- June 7, 2024
- Anko
Table of Contents
anko BOUNCE ACTIVITY CENTRE Instruction Manual
Read these instructions carefully before use and keep for future reference. The child may be hurt if you do not follow these instructions.
Supplied loose in box
Assemble
1 Connect the Rear L/H and R/H Base Frames to each other. Ensure the push pins are located in the holes.
2 Connect the Rear L/H and R/H Base Frame Assembly to the Front Base Frame
3 Insert the 2 x Side Support Frames into the Base Connectors.
4 The Activity Centre should now resemble the photo above
5 Slide the Seat Assembly Mountings onto the Side Support Frame.
To assemble Music & Lights Module
1 Turn Music and Light Module over and unscrew the battery cover. Insert 2 x
AA batteries (sold separately). Replace battery cover by screwing back into
place.
IMPORTANT! Please note that a screwdriver (not included) is required to
access the Toy Bar Battery Pack to insert 2 x AA
Batteries (sold separately).
2 Position the rear side of the Music and Light Module into the Main Frame. Push the front side of the Music and Light Module down to click into position.
PLEASE NOTE! The Toy Tray includes 7 melodies.
3 Push and twist the locking levers on the underside of the Main Frame to secure.
WARNING:
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (Nickle-cadmium)
batteries.
Adult supervision is required when charging rechargeable batteries.
Always remove flat or exhausted batteries from the toy.
Do not short-circuit the supply terminals.
Non-rechargeable batteries are not to be recharged.
To assemble Assorted Toys
1 Insert the Assorted Toys into the openings in the Seat Tray
2 All toys are interchangeable except the long bar toy which must be placed at the rear of the tray.
Battery Safety Information
In exceptional circumstances, batteries leak fluids that can cause a chemical
burn injury or ruin your product. To avoid leakage:
– DO NOT mix old and new batteries or batteries of different types: alkaline,
standard (carbon zinc) or rechargeable (Nickle-cadmium).
– Insert batteries as indicated inside the battery compartment.
– Remove batteries during long periods of non-use.
– ALWAYS remove exhausted batteries from the product.
– Dispose of batteries safely.
– DO NOT dispose of this product in a fire. The batteries inside may explode
or leak.
– Never short-circuit the battery terminals.
– Use only batteries of the same equivalent type and polarity, as recommended.
– DO NOT charge non-rechargeable batteries.
– Remove rechargeable batteries from the product before charging.
– If removable, rechargeable batteries are used, they are only to be charged
under adult supervision.
WARNING:
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc)
or rechargeable (Nickle-cadmium) batteries. Adult supervision is required when
charging rechargeable batteries. Always remove flat or exhausted batteries
from the toy. Do not short-circuit the supply terminals. Non-rechargeable
batteries are not to be recharged.
CARE AND MAINTENANCE:
– All assembly fittings are to be properly tightened. Inspect regularly and
re-tighten as necessary.
– To clean the seat pad, removable and non-removable fabric covers may be hand
washed or spot cleaned. Use mild soap or upholstery shampoo. Wash separately.
Do not bleach. Dry in shade thoroughly before re-use and avoid direct heat and
sunlight. Do not iron. Do not dry clean.
– To clean the Activity Centre, wipe with a damp cloth and dry immediately
with a soft clean cloth. Do not use abrasive pads, bleach or strong household
cleaners. Damage may result.
CAUTION:
Read these instructions carefully before assembly and use and keep for future
reference. The child may be hurt if you do not follow these instructions.
WARNING:
BEFORE ASSEMBLING THIS ACTIVITY CENTRE, READ AND UNDERSTAND THE INSTRUCTIONS.
Fall hazard; child’s activity may move activity jumper. Use only on floor. To
avoid tip over, place product on a flat, level surface. Never use this product
on an elevated surface, eg. A table. Strangulation hazard; strings can cause
strangulation!
Do not place items with a string around child’s neck, such as hood strings or
pacifier cords.
Do not suspend strings over product or attach strings to toys. Possible
entanglement or strangulation injury when toys are attached to activity
center.
Do not tie together with other toys. Remove all packaging and fasteners before
use. Begin using the product when the child can hold their head up unassisted
(up to a maximum weight of 12 kg / 26.5 lb.) and discontinue using the product
as a stationary activity center when the child begins to walk unassisted.
Never leave the child unattended. Always keep child in view while in product.
Never use near stairs.
Do not let children play with this product.
Do not move or lift this product with the baby inside it.
Do not use if any components are broken or missing.
Do not use the activity center as a swing.
Do not allow other children to play near the activity center. KEEP
INSTRUCTIONS IN A SAFE PLACE FOR FUTURE REFERENCE. KEEP PLASTIC COVERING AWAY
FROM CHILDREN TO AVOID SUFFOCATION.
WARNING STAIR HAZARD:
– Age range suitability: 6mths / 12 kg (26.5 lb.).
– Ensure all the locking equipment is installed well before using the activity
center.
– DO NOT use the activity center on a rough surface to avoid any injury to the
infant.
– DISCONTINUE USE of activity center when the child begins to walk unassisted.
Maximum weight 12 kg / 26.5 lb.
– This activity center does not replace a cot or a bed. Should your child need
to sleep, then it should be placed in a suitable cot or bed.
– A time limit of 20 minutes per use is recommended for the child to be in the
activity center.
– DO NOT use accessories or replacement parts other than those approved by the
manufacturer.
To insert Top Frame Plugs
1 Insert the Top Frame Plugs into the mounting connectors.
2 The Bounce Activity Centre is now ready for use.
WARNING:
Do not use the top frame plugs to carry the activity center.
To operate Seat Height Adjustment
1 There are three height adjustments that are changed by altering the position of the connectors on the underside of the Seat Tray.
2 To adjust, slide the plastic connector towards the seat to unlock. The position closest to the seat is the highest setting.
3 Reconnect by pushing the connector in and sliding it outwards to lock.
Keycode: 42836407
MADE IN CHINA
FOR AU / NZ: IMPORTED FOR KMART
STORES IN AUSTRALIA AND NEW ZEALAND.
FOR USA: IMPORTED BY ANKO RETAIL INC.
19500 ALDERWOOD MALL PARKWAY
LYNNWOOD WA 98036 USA.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>