My PowerForce®/Easy Vac® Lightweight Upright Vacuum is loud | Support
- June 7, 2024
- Bissell
Table of Contents
-
Unplug machine
-
Slide dirt cup release lever to the right to remove dirt cup and empty
-
Remove filter cup under dirt cup by pulling up
-
Grasp circular filters, twist counterclockwise to unlock, and pull straight up to remove
- Separate black foam filter from inner pleated filter
- Black foam filter can be washed in warm water with a mild detergent
- Allow to air dry completely before reinstalling
- Inner pleated filter is NOT washable and will need to be replaced when dirty
-
Remove separator from upper tank by twisting to unlock and pull straight down
- Separator can be rinsed with warm water
- Allow to air dry completely before reinstalling
-
Check hose inlet in upper tank for any clogs
-
Remove pre-motor filter below filter cup, turn machine on, and feel for suction at motor duct where filter sits
- If no suction at motor duct, visit a BISSELL Authorized Service Center or Contact Us
- Pre-motor filter can be washed in warm water
- Allow to air dry completely before reinstalling
-
Replace all filters and separator
-
Replace filter cup and lock dirt cup in place making sure there are no gaps between dirt cup and upper tank
-
Remove upholstery hose from back of machine by rotating hose downward toward unlock position and pull out to release hose from holder
- Run broomstick through hose to clear any clogs
- If hose is cracked or damaged, it will need to be replaced
-
Remove two screws on the left of the lower hose under the upholstery hose holder
- Run broomstick through lower hose to clear any clogs
- Brush cover can be removed to clear debris
-
If machine continues to be excessively loud, visit a BISSELL Authorized Service Center or Contact Us
-
Recipient Email
-
Your Email
Your Name
Was this answer helpful?
Yes
No
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>