axis C20 Series 2 Rearview Camera Installation Guide
- June 7, 2024
- AXIS
Table of Contents
axis C20 Series 2 Rearview Camera
SPECIFICATIONS
- 1/4” Full Colour CMOS Imaging Clip
- PC7070 Imaging Sensor
- Full Glass Lens
- 110° Wide Viewing Angle (Horizontal)
- 170° Wide Viewing Angle (Diagonal)
- PAL/NTSC (Switchable)
- Parking Guidelines (Selectable), Type, Height & Width (Adjustable)
- One Button Control of Image Orientation, Video Mode Select, Guideline Type, Guideline Height & Guideline Width
- Mirror, Normal, Upside-Down Mirror, Upside-Down Normal Image Orientation (Switchable)
- 0.3 Lux Minimum Illumination
- IP67 Water/Dust Protection
- 12/24V DC Power Input
- Number Plate or In-Bumper Mounting
- RCA Connection
- Dimensions: 16.5mm x 23mm (D)
INCLUDED:
- Dual Mounting Heads (Butterfly and Bumper Fit)
- Installation Manual
- Installation Hardware
- Metal Hole Saw for Bumper Fit Installation
- 6m Video Cable (RCA M)
CAR REARVIEW CAMERA
GENERAL:
After installation, the rear view system will automatically activate when
reverse gear is selected. This can provide a clear image for the driver and
protect children, pedestrians etc from injury. Also your vehicle will avoid
costly repairs from dents
and other damage when parking.
CAMERA:
The DUAL HEAD system included with your purchase allows for flexible
installation options, either surface mount (eg number plate or boot lid) or
stealth insert mount (eg bumper).
The RCA video cable simply connects with most aftermarket LCD monitors.
CAUTION:
Protective film (if attached) should be removed from camera before
operation.
Carefully check the +/- wiring sequence during installation. Ensure safety
when installing wires near the fuel tank .
CAMERA ASSEMBLY OPTIONS:
The C20 System is supplied with Dual Mounting Heads: Wing/Butterfly or Bumper
Fit.
Dual Mounting Heads
CABLE CONNECTIONS:
See wiring diagram below :
Selectable – Guidelines, PAL/NTSC &
Normal/Mirror Image.
- click, enter with/without guideline switching mode:
THE FOLLOWING MODES MUST BE OPERATED UNDER THE MODE WITH GUIDE LINE.
Operate to enter any mode you want 3 seconds after the previous mode.
- quick-continuous clicks, enter Mirror/Non-mirror switching mode;
- quick-continuous clicks, enter PAL/NTSC switching mode;
- quick-continuous clicks, enter GUIDELINE Type selecting mode;
- quick-continuous clicks, enter GUIDELINE Width adjusting mode;
- quick-continuous clicks, enter GUIDELINE Height adjusting mode.
INSTALLATION:
- Connect Monitor (sold separately) to Camera as per Wiring Diagram on page
- Determine installation location (usually the centre-rear of vehicle).
- Butterfly Type – Mount on surface using double-sided tape or screws
- Insert Type – Carefully drill hole (hole saw supplied) in bumper & insert camera
- Connect RED cable to 12/24V+ power cable of Reversing Light
- Connect BLACK cable to ground.
- Connect signal extension cable.
- Connect RCA (YELLOW) video cable to LCD
WARRANTY
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>