Nuby My Bathtime Clock and Thermometer User Guide
- June 7, 2024
- Nuby
Table of Contents
Nuby My Bathtime Clock and Thermometer User Guide
My Bathtime Clock & Thermometer has three different functions , working as a clock, thermometer & timer to keep bath time safe and fun.
THERMOMETER : Place in bath water. The top part of display will indicate the water temperature. It will display in Celsius or Fahrenheit. To switch from one to other, push “min” and “sec” buttons at same time. The temperature of the bath water should be approximately 98.6˚F/37˚C. If the light flashes green, the water is too cold. If the light flashes red, the water is too hot. AUTO COUNT UP: When the sensor comes into contact with water, the timer will automatically begin counting up, telling you how long your baby has been in bath. Never bathe an infant for longer than 5 minutes. CLOCK: To set the time on clock, hold “set” button until hours begin blinking. Use (+) and (-) buttons to set hours. Press “set” button again to set minutes. Press “set” a third time to set high temperature alarm. Press “set” again to return to normal display mode. TIMER: To set the timer, press “set” button. Use “min” and “sec” button to add minutes and seconds. Press “set” again to begin counting down. Timer will sound when time expires. Press “set” button during count down to pause timer. Press “min” and “sec” buttons at same time to clear timer. After the time has expired or been cleared the display will automatically return to clock mode. WARNING: PREVENT DROWNING. ALWAYS keep bathing child within arm’s reach. WARNING: Always use this product with adult supervision. KEEP BATTERY OUT OF CHILD’S REACH. SWALLOWING BATTERY COULD BE FATAL. BATTERY SHOULD NOT BE CHARGED ORPLACED INTO EXTREME HEAT AS IT MAY EXPLODE. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries. See below battery replacement instructions. Please retain these instructions for future reference.
