JOHN LEWIS Flush light User Manual
- June 7, 2024
- John Lewis
Table of Contents
User manual
Miles
Flush light
Thank you for purchasing this Miles flush light. Please read the instructions
carefully before use to ensure safe and satisfactory operation of this
product.
Warnings!
This is a Class 1 product and must be earthed.
Please read these instructions carefully before commencing any work.
It is recommended that this fitting is installed by a qualified electrician.
Install in accordance with the IEE Wiring regulations and the Building
Regulations.
To prevent electric shock switch off at mains supply before installing or
maintaining this fitting. Ensure other persons cannot restore the electrical
supply without your knowledge.
If you are in any doubt, please consult a qualified electrician.
This light fitting should be connected to a 5 amp fused circuit.
If replacing an existing fitting, make a note of the connections.
This product is not suitable for connection to dimmer switches.
This product is suitable for installation on surfaces with normal flammability
e.g. wood, plasterboard, masonry. It is not suitable for use on highly
flammable surfaces (e.g. polystyrene, textiles).
Ensure the correct fixings are used for the installation surface.
For your safety, always switch off the supply before cleaning or removing the
shade.
Parts list
| Parts list | Image | Qty |
|---|---|---|
| Light fitting | 1 | |
| Screws | 3 | |
| Wall plugs |  | 3 | |
| Shade | 1 |
Assembly
Refer to assembly drawing opposite. Carefully unpack the carton, making sure all the parts are present before assembly. The installation of the product will be easier with the help of an assistant.
Step 1
Use the light fitting (A) as a template to mark and make the screw holes. Pull
the house wiring through the fitting, and affix to the ceiling with the
appropriate fixings (B).
Step 2
Having identified the household wiring from your existing light fitting,
connect to the connection block inside the product as shown.
Check that
You have correctly identified the house wires. The connections are tight.
No loose strands have been left out of the connection block.
Step 3
Fit the shade (A) by placing over the fitting and twisting clockwise until it
locks in place.
Step 4
Replace fuse or circuit breaker and switch on. Your light is now ready for
use.
Care instructions
We recommend cleaning with a soft dry cloth. Do not use abrasive materials as
these will damage the finish.
Recommended bulb
1 x 12 Watt energy-efficient LED
This product contains a non-replaceable LED Module. If the LEDs become damaged
then the whole product must be replaced.
When moving or cleaning, always switch off at the mains and allow the module
to cool before handling.
Specifications
Max. power: 12W
Voltage: 240V, 50Hz
IP rating: IP20
Weight: 0.36kg
700-lumen output
Colour temperature: Warm white (3000K)
Please retain these instructions for future reference.
This symbol
indicates that this product should not be treated as normal household waste
and should be recycled. John Lewis do not operate instore take-back but as a
member of the
Distributor Trade Back schemes have funded the development and upgrade of
recycling facilities across the UK. Please take it to your nearest collection
facility or for further details contact your local council or visit www
.recycle-more.co.uk.
We have taken great care to ensure that this product reaches you in perfect
condition.
However, should any parts be damaged or missing please contact the Product
Helpline on (01202) 690945.
John Lewis Partnership
171 Victoria Street
London SW1E 5NN
johnlewis.com
Made in China
17/01/2020
References
- John Lewis & Partners | Department Store | Home, Fashion, Tech & More
- Everything you need to know to Recycle More