dogtra Barkmate Supreme Citronella Spray Bark N Train Collar User Guide
- June 7, 2024
- Dogtra
Table of Contents
Barkmate Supreme Citronella Spray Bark N Train Collar
The Barkmate Supreme Citronella Spray Bark N Train collar is a safe, humane and effective way for everyday dog training and anti-barking by delivering a short spray of harmless citronella gas towards the dog’s lower jaw.
Features:
- Suitable for sensitive dogs from 5kg & Up
- Collar Built-in Rechargeable Lithium battery
- Transmitter operated by 2 x AAA battery
- Water-resistant/weatherproof system
- Low battery and spray indicator
- Collar On/Off indicator
- Approximately 30-40 sprays per refill
Remote Training
- Range up to 150 meters
- Short and Long spray
- Low and a high warning beep
- Expandable to train up to 2 dogs with one remote
- Dog Collar selector with LED indicator
Anti Bark Collar
- Built-in bark/spray counter
- Low, Medium, and High Bark sensitivity setting
- Warning tone prior to spray correction
Transmitter
Red LED Indicator: When pressing the Short Spray/Long Spray/Low one/High
Tone button if the Red LED flashes once, it means Dog 1 has been selected. The
LED light will also flash red every few seconds to indicate the battery in
Transmitter is low.
Green LED: When pressing the Short Spray/Long Spray/Low one/High Tone
button if the Green LED flashes once, it means Dog 2 has been selected.
Dog 1 button: Press the button once to switch to dog 1. (Red LED light
should flash once)
Dog 2 button: Press the button once to switch to dog 2. (Green LED light
should flash once)
Short Spray button: Emits short one-second spray
Long Spray button: Emits a double amount one second spray
Low Beep button: Emits single low volume beep
High Beep button: Emits single high pitch beep
Collar On/Off button and Bark sensitivity switch
Spray Nozzle: From where the spray is ejected when the collar is
activated
Microphone Bark Sensor: Detects dog’s barking
Refill Port: Spray refill port
Two Colour LED Light: Green and Red LED lights to indicate Battery status
and Low spray warning
| Two Colour LED Light
---|---
Collar On/Good Battery| Green LED flashes once every 5 seconds
Low Battery| Red LED flashes once every second
Low Spray| Red LED flashes once every 5 seconds
While Charging the Collar| Red LED will be on
Fully Charged| Green LED will be on
Blue LED Indicator : Indicates the sensitivity settings in Low, Medium or
High. Low means the collar is harder to activate which is suitable for more
active dogs or household with more than one dog. Medium is the default setting
for most barking dogs. High means the collar is very easy to be activated. It
is great to test the bark function of the collar manually.
On/Off Button: Press and hold the button for 2 seconds to turn the collar
on or off. 2 short beeps to indicate the collar is on and a long beep to
indicate the collar off. Press the On/Off button once when the collar is on to
switch the bark sensitivity settings.
USB Charging Port: Recharge the collar with a USB cable
Fitting the Supreme Citronella Spray Bark N Train Collar
Important: It is important to fit the collar on the dog properly to make
it work. To assure a proper fit, please follow the steps:
- Make sure that the collar is turned off. Avoid turning the collar on/off while it is on your dog.
- Start with the dog standing not sitting.
- Place the Barkmate Spray bark collar high on your dog’s neck close to the ears.
- Position the unit underneath your dog’s neck with the spray nozzle facing upward.
- It is recommended to trim the fur a little bit for the long-haired dogs so it won’t block the bark sensor.
- Fit the collar snuggly as a loose fit may cause false activation
- Check for a firm fit of the Bark Control Collar by inserting one or two fingers between the collar and the back of the dog’s neck. The fit should be snug but not constricting.
- Allow your dog to wear the collar for a few minutes, then check the fit again.
Recharging the Barkmate Spray Collar
The LED light will flash red every second when the battery is low. Use the
supplied USB cable to charge the Barkmate Spray Collar. It can be charged via
the USB port of a computer or any USB AC charger. It normally takes around 2
to 3 hours to charge the collar and the LED will turn green when it is fully
charged.
How the Barkmate Supreme Citronella Spray Collar Bark Feature Works
The Barkmate Supreme Collar has a built-in Auto Bark function. If you want to
use the collar as anti bark collar only please follow the steps:
- Turn the collar off.
- Turn the collar on but DO NOT press any buttons on the remote transmitter
3. Wait for 1 minute without pressing any buttons on the remote. The collar
will turn into anti bark collar after 1 minute. If you press one of the
buttons during the waiting period, the collar will stay in remote training
collar mode. It won’t turn into anti-bark mode.
When the Barkmate Supreme collar in the anti bark collar mode, the bark sensor
will detect the barking from the dog, then it emits a warning beep. If the dog
doesn’t stop barking, the collar will emit a burst of citronella spray to
distract the dog with the smell of the spray to deter barking.
If you want to use the Barkmate Supreme Spray collar as a remote training
collar again, please follow the
steps:
- Turn the collar off
- Turn the collar on then press any Tone/Spray buttons on the remote transmitter immediately.
- The collar will become a remote training collar again.
Packaging Includes
1 x Barkmate Supreme remote transmitter
1 x Barkmate Supreme receiver collar
2 x AAA battery (already installed in the transmitter)
1 x USB charging cable
1 x 60g Barkmate Citronella Spray
1 x Lanyard for remote handheld transmitter
Trouble Shooting Guide
The Spray Collar Sprays but the dog is still barking –
Check to make sure the Spray Nozzle points towards the dog’s snout. Also, make
sure the dog’s fur does not block the spray.
The Battery ran out of charge very quickly –
You may find after the first few uses the battery runs down a little more
rapidly because the dog is still
learning that the bark triggers the spray. Be sure the collar is turned off
when not in use.
Spray leaks out when refilling –
The Spray canister has to be held vertically straight when filling. The best
way to do this is by putting the collar on a flat table when refilling the
collar. Check to see if there is any spray residue built up in the spray
nozzle & clear if necessary, with a fine tip brush.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>