Whirlpool WED5010LW White Moisture Sensing Electric Dryer User Guide
- June 7, 2024
- Whirlpool
Table of Contents
Whirlpool WED5010LW White Moisture Sensing Electric Dryer
DETAILED PLANNING DIMENSIONS
Electrical Requirements
Fuel Type
|
Electric
|
Gas
Minimum Circuit Amperage Rating|
30A
|
15A
Maximum AMP Draw|
26A
|
6A
Operating Voltage|
120/240 V – AC only
|
120 V – AC only
Current Canada Rating|
24A
Operating Frequency|
60 Hz
Product Dimensions
|
in
|
mm
A| Height (With leveling legs not extended)|
40 1/2
|
1028
B| Width|
29
|
737
C| Top Height (with min. feet)|
36 7/8
|
937
D| Depth|
28 8/3
|
722
E| Top Height (With leveling legs fully extended)|
38 1/2
|
978
F| Height (With leveling legs fully extended)|
42 1/8
|
1069
G| Depth with Door Open|
4111∕16
|
1059
Product Dimensions
|
in
|
mm
H| Strain Relief from Side (electric)|
15 3/4
|
400
I| Strain Relief Height (electric) (With leveling legs not extended)|
28 1/8
|
714
J| Exhaust Duct from Side|
14 7/16
|
366
K| Power Cord from Side (gas)|
14 3/4
|
375
L| Power Cord Height (gas)|
32 3/8
|
822
M| Gas Connection (With leveling legs not extended)|
1 11/16
|
43
N| Gas Connection from Side|
9 3/16
|
234
O| Strain Relief Height (electric) (With leveling legs fully extended)|
29 3/4
|
755
P| Exhaust Duct Height (With leveling legs fully extended)|
6 11/16
|
170
Q| Power Cord Height (gas)|
34
|
863
R| Gas Connection (With leveling legs fully extended)|
3 5/16
|
84
S| Exhaust Duct Height (With leveling legs not extended)|
5 1/16
|
128
| Gas Power Cord Length|
60
|
1525
Spacing for recessed area or closet installation
The dimensions shown are for the recommended spacing allowed.
- Additional spacing should be considered for ease of installation and servicing.
- Additional clearances might be required for wall, door, and floor moldings.
- Additional spacing of 1″ (25 mm) on all sides of the dryer is recommended to reduce noise transfer.
- For closet installation, with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilations openings are acceptable.
- Companion appliance spacing should also be considered.
