NORTHSTAR 1571110 Wall Mounting Kits for Pressure Washer Owner’s Manual
- June 7, 2024
- NORTHSTAR
Table of Contents
NORTHSTAR 1571110 Wall Mounting Kits for Pressure Washer
KIT PART #
|
USED ON
NorthStar ITEMS:
---|---
1571110
|
1571107, 1571108, 1571109
REF
|
PART#
|
DESCRIPTION
|
QTY
|
KIT
---|---|---|---|---
1
|
802874
|
Wall Mount Bracket
|
1
|
1571110
Initial Set-Up
Step 1. Inspect & Unpack
Upon receiving your item check for missing or damaged parts.
- For missing or damaged components, please contact Product Support at 1-800-270-0810.
Hardware Bag
Step 2. Assembly
Note: Remove contents from box and begin assembly.
Wall Mount Bracket Assembly
Step 1: Remove the rubber bumper if present on the pressure washer.
Step 2: Install wall mount bracket # 802874 using self-tapping screws# 82082
qty-4.
Step 3: Mount entire assembly on to the wall mount bracket using bolts #82621
and lock nut # 82630 qty-4.
Step 3. Select Suitable Location
Moving and Handling
Elevating or lowering your pressure washer
- To reduce risk of injury, it is recommended that two adults lift the pressure washer or a lifting device is used such as an overhead hoist or forklift.
- Only lift the pressure washer by the base. Do not use the pump or motor as lifting point. See component identification for lifting point locations.
Positioning:
- The pressure washer should be positioned on a firm, level (less than 3-degree slope), heat-resistant surface with good drainage and a nearby water supply.
- The pressure washer should be placed within garden hose distance of a continuous water supply. Ensure that the pressure washer sits level and will not slide or shift during operation.
Airflow:
- Situate so there is adequate clearance around pressure washer to allow for airflow – at least 7 feet from any non-combustible wall or obstruction.
- Do not operate with a tarp, blanket, or cover surrounding the pressure washer.
- Do not place any objects against or on top of the pressure washer.
- The pressure washer needs adequate, unobstructed flow of air to allow for adequate cooling. Cooling ventilation is required to prevent overheating of the pressure washer and possible fire.
- Keep a fire extinguisher rated “ABC” nearby.
Assembled by
Northern Tool & Equipment Company, Inc.
Burnsville, MN 55306
NorthernTool.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>