TC HELICON Harmony Singer 2 Vocal Processors User Guide
- June 7, 2024
- TC-HELICON
Table of Contents
Quick Start Guide
HARMONY SINGER 2
V 1.0
Visit musictribe.com to download the full manual
Controls
- Key Selector Selects a major key for pitch correction. CH setting is Harmony Selects the harmonies that will be blended with your voice.
- Ground lift If you experience buzz or hum, try pressing the ground lift button in or out.
- Guitar thru
- Level Adjusts the volume of the harmonies.
- USB Accepts micro-USB cables for firmware updates.
- On/Off
- Reverb Selects the type and amount of reverb effect.
- Guitar input
- Tone Engages `Adaptive Tone’ for EQ, compression, de-essing and gating.
- Footswitch Bypass the harmony effect with a single press. Holding for a few seconds bypasses harmony and reverb effects.
- Out Connect to a mixer or powered speaker.
- Mic Connect your microphone.
- Power Connect a 9V / >300 mA power supply, such as the PowerPlug 9 (not included). The pedal also accepts4 x AA batteries.
FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION
TC Helicon
HARMONY SINGER 2
| Responsible Party Name: | Music Tribe Commercial NV Inc. |
|---|---|
| Address: | **5270 Procyon Street, |
Las Vegas NV 89118,
United States
Phone Number:| +1 702 800 8290**
HARMONY SINGER 2
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Important information:
Changes or modifications to the equipment not expressly approved by Music
Tribe can void the user’s authority to use the equipment.
Operation Ambient Temperature up to 45°C.
Hereby, Music Tribe declares that this product is in compliance with Directive
2014/30/EU, Directive 2011/65/EU and Amendment 2015/863/EU, Directive
2012/19/EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at
https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S Address: Ib Spang Olsens Gade 17,
DK – 8200 Aarhus N, Denmark
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>