ROCKVILLE RWS WiringDiagram User Manual

RWS1OCA/RWS12CA
WIRING GUIDE

FEATURES

1. High-Level Input
   High-Level inputs also referred to as speaker-level inputs, allow you to connect to the factory speaker sos. They are called High-Level inputs Wane they convert the high voltage running through factory speaker wires to one the smellier can handle. These inputs wit provide the end-user with clear well- defined sound fa opting for musical enjoyment.

2. Bass Remote:
   Connect dash-mounted bass remote (included) via Rill cede (included).

3. RCA Input
   Connect to your head hurts RCA outputs.

4. Gain control:
   The gain control regulates the %ohne input to the pre-amp stage.

5. Low Pass Crossover control:
   Adjust Levi Pass frequency from 40Hz – SSC&

6. Power/Protect LED ideates

7. Power connections
   See the Wiring diagram for proper setup.

8. Fuse

HIGH-LEVEL INPUT

WARNING: Use either High-Level inputs or RCA inputs. NEVER USE BOTH!
WARNING: Do not use Remote Turn-on (REM) when using High-Level inputs.

WIRING

|

RCA INPUT/BASS REMOTE

---|---
ATTENTION: The ground wire should be 8 gauge or heavier Ensure that there is no paint or other insulator at the point of contact on the chassis.
WARNING: Do not use Remote Turn-on (REM) when using High-Level inputs.| ATTENTION: II your Head Unit has an RCA subwoofer output, use a single RCA to dual RCA cable.
WARNING: Use either High-Level inputs or RCA inputs. NEVER USE BOW
|

https://vimeo.com/showcase/7766999

Go to vimeo.comishowcaseM66999 or scan the QR code and watch a short video, which shows you how to set this item up and how to use it.

RockvilleAudio.com
02021 ROCKVIU.E
The intamation presented is subject to change and/or improvement without notice.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>