DIGITUS 16 Port Gigabit Switch Installation Guide

: June 7, 2024
: DIGITUS

Table of Contents

About The Guide
Product Introduction
Hardware installation
Technical specifications
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

DIGITUS 16 Port Gigabit Switch Installation Guide

About The Guide

This guide provides instructions to install the Ethernet Switch

Note: The model you have purchased may appear slightly different from the
illustrations shown in the document. Refer to the Product Instruction and Technical Specification sections for detailed information about your switch, its components, network connections, and technical specifications.

This guide mainly divides into 3 parts:

Product introduction: functional overview and introduction of panel definitions
Hardware installation: step by step hardware installation process
Technical specifications

Product Introduction

The 16-Port Gigabit Switch from DIGITUS® provides 16 x Gigabit RJ45 ports along with 2 SFP uplink ports with 1 Gigabit bandwidth. Expand the existing network easily, a backplane bandwidth of 36 Gbps is available. The switch can be installed in 10-inch server cabinets and housings. The power adapter is already integrated into the sturdy, fanless housing. Ideal for extending/setting up small home or company networks.

Front Panel
The front panel consists of LED indications and network ports.

LED Lamp
Power LED: The Power LED lights up when the switch is connected to a power source.
Link/Act indicator: The light indicates the network connection through the corresponding port. Flicker indicates that the switch is sending or receiving data.

Rear Panel
The rear panel view of the Switch consists of an AC power connector.

Grounding: use specialized ground lead connect

100 – 240 V AC: Connect the power adapter output terminal to this port.
Supports input voltages

Hardware installation

This chapter provides unpacking and installation information for the Ethernet Switch

Package Content
Open the shipping carton and carefully unpack its contents. Please consult the packing list located in the QIG to make sure all items are present and undamaged. If any item is missing or damaged, please contact the local reseller for replacement.

Switch 1pcs
AC power cord 1pcs
QIG 1pcs

Switch Installation
For safe switch installation and operation, it is recommended that you:
Visually inspect the power cord to see that it is secured fully to the AC power connector. Make sure that there is proper heat dissipation and adequate ventilation around the switch. Do not place heavy objects on the switch.

Installation Hole Spacing

Plugging in the AC Power Cord
You can connect AC power supply cord to switch back and the other side connect the power outlet (power outlet might as well grounding and support over voltage protection).

Warning: Do not turn on the power switch before power cables are connected.
Power surge may cause damage to the Switch.

Power failure: As a precaution, the switch should be unplugged in case of power failure. When power is resumed, plug the switch back in.

Network Connection

①+ ②: IP camera, ③+ ④: Camera, ⑤: Network video recorder Cable: Cat 5 and higher

Technical specifications

Fixed port	16 Port 10/100/1 000Base-TX with 2 Gigabit SFP Port
Standards and protocols	IEEE802.3 10Base-T Ethernet standard

IEEE802.3u 100Base-TX Fast Ethernet standard IEEE802.3ab 1000Base-T Ethernet standard IEEE802.3z Gigabit Ethernet (fiber)

IEEE802.3x Full duplex flow control and Backpressure Half duplex flow control

IEEE802.3ab Link aggregation

This is a Class A product. In home environment, this product may cause radio interference. In this case, the user may be required to take appropriate measures.

Hereby Assmann Electronic GmbH, declares that the Declaration of Conformity is part of the shipping content. If the Declaration of Conformity is missing, you can request it by post under the below mentioned manufacturer address.

Contact us
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany