DYNOJET 17-086 Power Commander V User Guide
- June 3, 2024
- Dynojet
Table of Contents
DYNOJET 17-086 Power Commander V
Model coverage: 2022 Kawasaki KLR650
PARTS LIST
- 1 POWER COMMANDER V
- 1 INSTALLATION GUIDE
- 1 USB CABLE
- 2 DYNOJET DECALS
- 2 POWER COMMANDER DECALS
- 2 VELCRO STRIPS
- 1 ALCOHOL SWAB
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.
THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.
INPUT ACCESSORY GUIDE
ACCESSORY INPUTS
Map| (Input 1 or 2) The PCV has the ability to hold two different base
maps. You can switch on the fly between these two base maps when you hook up a
switch to the MAP inputs. You can use any open/close type switch. The polarity
of the wires is not important. When using the Autotune kit, one position will
hold a base map and the other position will let you activate the learning
mode. When the switch is “CLOSED” Autotune will be activated.
---|---
Shifter| (Input 1 or 2) These inputs are for use with the Dynojet quick
shifter. Insert the wires from the Dynojet quick shifter into the SHIFTER
inputs. The polarity of the wires is not important.
Speed| If your application has a speed sensor then you can tap into the
signal side of the sensor and run a wire into this input. This will allow you
to calculate gear position in the Power Core software. Once gear position is
setup you can alter your map based on gear position and setup gear dependent
kill times when using a quick shifter.
Analog| This input is for a 0-5v signal such as engine temp, boost, etc.
Once this input is established you can alter your fuel curve based on this
input in the Power Core software.
Crank| Do NOT connect anything to this port unless instructed to do so
by Dynojet. It is used to transfer crank trigger data from one module to
another.
WIRE CONNECTIONS
To input wires into the PCV first remove the rubber plug on the backside of
the unit and loosen the screw for the corresponding input. Using a 22-24 gauge
wire, strip about 10mm from its end. Push the wire into the hole of the PCV
until is stops and then tighten the screw. Make sure to reinstall the rubber
plug.
NOTE: If you tin the wires with solder it will make inserting them
easier.
INSTALLING THE POWER COMMANDER V
-
Remove the seat.
-
Remove the luggage brackets and top rack if installed.
-
Remove the side panels.
-
Remove the rear cowl section.
-
Unplug the stock wiring harness from the ECU.
-
Plug the PCV in-line of the stock wiring harness and ECU.
-
Using the supplied velcro secure the PCV to the inner rear fender. Make sure to use the alcohol swab to clean the surface before attaching.
-
Reinstall bodywork.
**PUSH**
**THE**
**LIMIT**
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081
–800-992-4993 –
DYNOJET.COM
© 2020-2021 DYNOJET RESEARCH ALL RIGHTS RESERVED
Documents / Resources
|
DYNOJET 17-086 Power Commander
V
[pdf] User Guide
17-086 Power Commander V, 17-086, Power Commander V, Commander V, Power
Commander, 2022 Kawasaki KLR650
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>