SYLVANIA XJ066 ValueLED CCT Selectable Small Wallpack Instruction Manual
- June 4, 2024
- SYLVANIA
Table of Contents
SYLVANIA XJ066 ValueLED CCT Selectable Small Wallpack
ValueLED CCT Selectable Small Wallpack
The ValueLED Small Wall Pack luminaires are environmentally preferable LED alternatives to traditional HID luminaires, offering up to 68% in energy savings. Ideal in place of traditional luminaires, or as new installations, the Small Wall Pack series is offered in several wattages/lumen packages for illuminating building exteriors, outdoor corridors, walkways, and stairwells.
WARNING
Please Read All Instructions Before Attempting Installation
- PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
- TO PREVENT PERSONAL INJURY OR PRODUCT DAMAGE ONLY LICENSED ELECTRICIANS SHOULD PROVIDE ALL INSTALLATION SERVICES.
- TO AVOID ELECTRIC SHOCK OR COMPONENT DAMAGE DISCONNECT POWER BEFORE ATTEMPTING INSTALLATION OR SERVICING.
- THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE NATIONAL ELECTRIC CODE (NEC) AND ALL APPLICABLE FEDERAL, STATE AND LOCAL ELECTRIC CODES AND SAFETY STANDARDS.
- USE CAUTION WHEN HANDLING THIS PRODUCT DURING OR AFTER OPERATION AS IT MAY BECOME HOT AND CAUSE BURNS. DISCONNECT PRODUCT AND ALLOW COOLING PRIOR TO SERVICING.
- ANY ALTERATION OR MODIFICATION OF THIS PRODUCT IS EXPRESSLY FORBIDDEN AS IT MAY CAUSE SERIOUS PERSONAL INJURY, DEATH, PROPERTY DAMAGE AND/OR PRODUCT MALFUNCTION.
- TO PREVENT PRODUCT MALFUNCTION AND / OR ELECTRICAL SHOCK THIS PRODUCT MUST BE PROPERLY GROUNDED.
- THIS LUMINAIRE IS TO BE WALL MOUNTED ONLY.
- THIS LUMINAIRE IS DESIGNED TO OPERATE IN AMBIENT TEMPERATURES RANGING FROM -40°F TO + 104°F (-40°C TO +40°C).
Safety Precautions
Important:
Read carefully before installing the fixture. Retain for future reference.
General:
Upon receipt of the fixture, thoroughly inspect for any freight damage which
should be brought to the attention of the delivery carrier. Sensor is located
under the lens (all models ship preset at 4000K).
Installation
Standard Installation Wall mount
- Before starting, ensure that the power is disconnected.
- Remove the 2 Torx screws (1 on each side) that hold the front plastic housing to the back and remove the front housing. (See figure 1)
- Loosening the 2 screws (C) that hold the reflector (A) in place, ensuring that the quick connectors are disconnected (B). (See figure 2)
- Remove the conduit plug cover in either the bottom or the back of the housing.
- To mount the rear housing knock out appropriate holes around the outlet hole in the rear housing.
- If 3000 or 5000K are desired, please adjust the CCT switch
- Wire the fixture according to the wiring diagram below.
- Install rear housing to the junction box using screws supplied with the junction box.
- Replace reflector and front housing using screws removed in steps 2 and 3.
- To ensure a watertight seal caulk between the rear housing and the mounting surface.
References
- LEDVANCE US and Canada | SYLVANIA General Lighting | Home Page
- LEDVANCE US and Canada | SYLVANIA General Lighting | Home Page
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>