FORCE CORELLA Helmet for Cyclists Instruction Manual
- June 9, 2024
- FORCE
Table of Contents
CORELLA Helmet for Cyclists
HELMET FOR CYCLISTS – INSTRUCTIONS FOR USE
This is a helmet for cyclists providing protection for the top of the user’s
head. Suitable for
cycling or scooter riding. This product is personal protective equipment whose
primary
function is to protect the top of the user’s head from hazards that may arise
during cycling
and scooter riding activities. The device protects the head from impacts where
part of the
impact energy is absorbed by the helmet, thereby reducing the impact energy to
which the
head is exposed. The protection provided by the helmet depends on the
circumstances
surrounding the injury and cannot always protect against injury. The helmet
only protects if
it is well seated on the head. The buyer must try on di…erent sizes and choose
a helmet that
ts his or her head securely and comfortably. With the help of spare padding
(not applicable
for integral helmets), the internal size can be adjusted to the optimum shape.
The helmet
must be adapted to the user. Correct routing of the strap under the chin
without covering the
ears is essential. The buckle, when properly adjusted, should t snugly and
comfortably
under the chin (away from the jaw) so that the helmet stays on the head in the
event of a fall.
The straps and buckle must be comfortably and rmly adjusted. The helmet must
not be
worn too far back and must t so as to protect the front of the head. Original
helmet
components must not be removed or altered under any circumstances. Do not
expose the
helmet to temperatures exceeding 60°C, do not clean with synthetic agents
(lukewarm water
is suˆcient). Helmets damaged by a fall must no longer be used! The helmet
must not be
used for activities other than those for which it is intended (do not use when
riding a
motorcycle)! Warning! This helmet is not to be used by children when climbing
and other
activities in which there is a risk of strangulation/hanging by the helmet in
the event of a
child falling! Never pull over the stop when adjusting the wheel! If the
helmet has been
subjected to a severe impact the damaged piece must be replaced and disposed
of. Select the
correct helmet size according to the head circumference in cm. The above also
applies to
integral cycle helmets with regard to their construction and specication. We
declare that
this cycle helmet complies with Regulation (EU) 2016/425 of the European
Parliament and of
the Council of 9 March 2016 on personal protective equipment. Notied body
involved in the
conformity assessment of PPE; Telecation BV, Edisonstraat 12A, 6902 PK
Zevenaar,
Netherlands. NB 0560. TR: SZHH01372967; SZHH01346068. The current declaration
of
conformity can be found on the website www.force.bike in the “Documents to
download”
section for the product in question. KCK Cyklosport-Mode s.r.o., Bartošova
348, 765 02
Otrokovice-Kvítkovice, Czech Republic
Correct t of the helmet (points 1 and 2 do not apply to integral
helmets):
- Look upwards to make sure you can only see the edge of the helmet.
- The side straps should be attached just below the ears, in the shape of a ‘Y’.
- When you fasten the strap and open your mouth wide, you should feel the helmet pulling down.
PRODUCER
ZHONGSHAN HENXIN SPORTS EQUIPMENT CO, NO. 15 RAINBOW RD, TANZHOU TOWN,
ZHONGSHAN CITY, GUANGDONG, CHINA
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>