Planet Audio PATV65RGB 450 Watt Powersports Plug and Play Bluetooth Sound System User Manual
- June 6, 2024
- Planet Audio
Table of Contents
- Planet Audio PATV65RGB 450 Watt Powersports Plug and Play Bluetooth Sound
- IMPORTANT SAFETY PRECAUTIONS
- INSTALLATION PRECAUTIONS
- BEFORE INSTALLING THIS PRODUCT
- WIRE DIAGRAM
- SPEAKER MOUNTING SUGGESTIONS
- BLUETOOTH OPERATION
- PAIRING & DISCOVERING A NEW BLUETOOTH CONNECTION
- GETTING TO KNOW YOUR PATV65RGB LED RF CONTROLLER
- INFORMATION TO THE USER
- SPECIFICATIONS
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Planet Audio PATV65RGB 450 Watt Powersports Plug and Play Bluetooth Sound
System
IMPORTANT SAFETY PRECAUTIONS
- BE SURE TO OBSERVE THE FOLLOWING GUIDELINES:
- Do not turn up the volume so high that you can’t hear what’s around you.
- Use caution or temporarily discontinue use in potentially hazardous situations.
- Do not operate mobile video equipment while driving a motorized vehicle – safe driving and safety consideration of others should always be your highest priority.
- Set your volume control at a low setting, then slowly increase the sound until you can hear it comfortably without distortion, or ear discomfort.
- In the event you should notice smoke, strange noises or odor from this product, or any other abnormal signs, immediately turn off the power and consult your dealer or the nearest authorized PLANET AUDIO Service Center. Using this product in this condition may result in permanent damage to the system.
INSTALLATION PRECAUTIONS
WARNING – Always consult with a professional installer
-
Professional installation recommended. Do not attempt to
service this product by yourself. Servicing of this product by persons without professional training and experience in electronic equipment and motorized vehicle accessories may be dangerous and could expose you to the risk of electric shock, injury or other hazards. Contact Planet Audio for any installation, service questions or requests. -
Refer any repairs to a qualified PLANET AUDIO Service Center
-
The PATV65RGB should be powered directly to a vehicles battery
-
When wiring directly to the vehicles battery, be sure to disconnect the batteries negative terminal wire before starting any wiring procedures. if extending the main power wire, it is suggested that an optional fuse and fuse holder (not included) with minimum rating of 20 Amperes be in-line with the positive battery terminal
-
The ground cable length should not exceed 18-inches
-
The PATV65RGB has a weather resistant design, it should not be submerged in or under water under any circumstances
-
Use only the installation parts provided with the PATV65RGB
CAUTION! Using other mounting methods may void this warranty
BEFORE INSTALLING THIS PRODUCT
To avoid potential shorts in the electrical system, be sure to disconnect the(-) battery cable before installation. Use this unit with a 12-volt battery and negative grounding only. Failure to do so may result in a fire or malfunction.
When replacing the fuse, be sure to only use a fuse of the rating specified on this product.
To avoid short-circuiting, cover any disconnected leads with insulating tape.
It is especially important to insulate any unused wires, which if left
uncovered may cause a short circuit. When connecting other devices to this
product, refer to the manual for the product to be connected. The black cable
is ground, make sure to connect the ground wire first.
Ensure that the ground cable is properly connected to metal parts of the
vehicles body frame or direct to the battery if your vehicle does not have a
grounded chassis frame The ground cable of this units power amp and a second
powered system must be connected to the frame separately with different
screws. If the screw for the ground wire loosens or falls out, it could result
in fire or malfunction.
TECHNICAL SUPPORT
1.805.751.4854
www.planetaudio.com/technical-support
WIRE DIAGRAM
SPEAKER MOUNTING SUGGESTIONS
BLUETOOTH OPERATION
PAIRING & DISCOVERING A NEW BLUETOOTH CONNECTION
ANDROID users:
- Go into the Setting Menu of your device.
- Enter the Bluetooth Menu and press SCAN
- “ Planet Audio ATV ” will now be display under AVAILABLE DEVICES
- If prompted, enter passcode: “ 0000 “
iOS users:
-
Go into the Setting Menu of your iOS device.
-
Enter the Bluetooth Menu
-
“ Planet Audio ATV ” will now be displayed
-
If prompted, enter passcode: “ 0000 “
-
If Planet Audio ATV is not seen, repeat the above steps to refresh the “ Device List “
-
When the connection is successful the BLUE LED will be ON , you are now ready to stream music from your devices favorite media player to the PATV65RGB
GETTING TO KNOW YOUR PATV65RGB LED RF CONTROLLER
- When use for the first time, pull out the film protruding the tray
- RF controller range: Up to 25ft (LoS)
- Do not obstruct the RF remote with metal
- Always keep away from small children
- Do not store in direct sunlight
- Do not submerge in mud and/or water
INSTALLING THE BATTERY
- Slide the tray out on back of the remote control and insert battery with the (+) and minus (-) poles pointing in the proper direction
- RF CONTROLLER
- RGB ON/OFF
- MODE UP
- AUTO DEMO (LONG PRESS FOR SINGLE COLOR MODE) SPEED UP
- BRIGHTNESS UP
- BRIGHTNESS DOWN
- MODE DOWN
- COLOR DOWN
- COLOR UP
- SPEED DOWN
- LIGHT BAR ON/OFF
INFORMATION TO THE USER
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause interference, and
- This device must accept any interference, including interference that may cause undesired operation of this device.
This transmitter must not be co-located or operated in conjunction with any
other antenna or transmitter. The Bluetooth antenna cannot be removed (or
replaced} by user. This equipment complies with FCC/ IC radiation exposure
limits set forth for an uncontrolled environment and meets the FCC radio
frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF)
Exposure rules. This equipment has very low levels of RF energy that it deemed
to comply without maximum permissive exposure evaluation (MPE). But it is
desirable that it should be installed and operated keeping the radiator at
least 20 cm or more away from person’s body (excluding extremities: hands,
wrists, feet and ankles). Alteration or modifications carried out without
appropriate authorization may invalidate the user’s right to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Relocate or reorient the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SPECIFICATIONS
BLUETOOTH
- Version: 3.0 + / EDR
- A2DP
- Range: 33ft (10m) Class 2
SPEAKERS
- Dimensions: 6.5″
- Impedance: 4 OHM
- Cone Type: PP CARBON + RUBBER SURROUND
- Tweeter Size: 1″ PEI SOFT DOME
AMPLIFIER
- Input Impedance: 10 OHM
- Frequency Response: 45Hz-25KHz
CHASSIS
- Weight: 14.5lbs / 6.58KG
- Unit Dimensions cm HxDxW: 20.2 x 32.2 x 72.4
- Unit Dimensions inches HxDxW: 7.95 x 12.67 x 28.50
- Quick Release Power Adapter
GENERAL
- Operational Power: 14.4VDC (10.8 ~ 16V allowable)
- Grounding System: Negative type
- MAX Current Draw: 13.7A
- Replacement Fuse: 10A AGC TYPE
- 3-way protection circuitry (thermal, overload and speaker short protection)
- Color: Black
- Storage Temperature: 5°F to 158°F / -15°C to 70°C
- Operation Temperature: 14°F to 140°F / -10°C to 60°C
Customer Service
805-7.51-4854
TECHNICAL SUPPORT
www.planetaudio.com/support
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>